DrRobot MAC5310 Manual del usuario - Página 3
Navegue en línea o descargue pdf Manual del usuario para Amplificador DrRobot MAC5310. DrRobot MAC5310 5 páginas. Audio codec and audio power amplifier module
I.
Introduction
The MAC5310 Audio Codec and Audio Power Amplifier Module can be used as audio input/output interface in
the WiRobot system by plugging into the PMB5010 Multimedia Controller board. The on-board codec provides
high resolution signal conversion from digital-to-analog (D/A) and from analog-to-digital (A/D) using over-
sampling sigma-delta technology. With the on-board audio output power amplifier and the microphone preamp
in the codec, the external speaker and microphone can be directly connected to the MAC5310 board.
Features
•
16-bit over-sampling sigma-delta A/D, D/A converter
•
Maximum output conversion rate:
-
16 ksps with on-chip FIR filter
-
64 ksps with FIR bypassed
•
Codec built-in FIR produces 84-db SNR for ADC and 85-db SNR for DAC over 11-kHz BW
•
2s-complement data format
•
Codec built-in functions including PGA, anti-aliasing analog filter, and operational amplifiers for general-
purpose interface (such as MIC interface and hybrid interface)
•
On-board audio output power amplifier can support up to 1.5 W power to the external speaker
•
On-board oscillator
•
Plug-and-play in the WiRobot system
Applications
•
Audio input/output for robotic systems
•
Voice and speech recognition
•
Voice and audio playback
II.
Operations
II.1.
Theory of Operation
The MAC5310 Module is designed to run as part of WiRobot system. It can be directly plugged on to the
PMB5010 Robot Multimedia Controller board. No configuration procedure is needed. Once connected, the
PMB5010 on-board firmware and the audio input/output device driver will take care of the low level operations
of the voice/speech capturing and audio output.
III.
Connections
III.1.
Board Structure
Figure III.1 shows the board structure, locations and functions of the connectors on the MAC5310 module board.
Copyright © Dr Robot Inc. 2003.
2