anko LD-K3064 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Hervidor anko LD-K3064. anko LD-K3064 9 páginas.

Warning - risk of burns / scalding

* Always place the water kettle on a solid and even surface.

Ensure that it cannot slip or be dropped and that the power cord does not hang down.

* The kettle becomes hot while in use. Do not move the kettle during operation and do not pull

on the mains cord. Only hold/lift the hot kettle by its handle.

* Contact with rising steam can cause scalding! Make sure the lid is always firmly closed and

do not open it while water is boiling or while pouring water out.

* Do not fill the container with less than Min. (0.5L) or more than Max. (1.7L) of water.

If there is not enough water in the kettle, the appliance may overheat.

* Be sure that the kettle is switched OFF before taking it off the power base.

* The kettle is only to be used with the stand provided.

* If the kettle is overfilled, boiling water may be ejected.

* CAUTION! The heating element and surfaces are subject to residual heat after use.

* WARNING – Avoid water spillage on the electrical connectors.

* WARNING – Potential injury from misuse.

* WARNING – Do not remove the lid while the water is boiling.

IMPORTANT!

* Take care that any steam escaping from the appliance cannot damage wall paper, wall

cabinets or other items. Turn the spout away from furniture and walls.

* Do not use caustic, aggressive or abrasive cleaning products for cleaning.

Keep hard items away from the appliance.

* Although the kettle is protected from boiling dry, it must never be operated without water.

* If the overheat cut-out switch switches OFF the kettle to prevent overheating and boiling dry,

proceed as follows:

- Take the kettle from the base.

- Allow the kettle to cool down for at least 15 minutes before refilling it with fresh water and

replacing the kettle back on the power base.

* Only use the kettle with the power base provided.