anko LD-K3078 Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Hervidor anko LD-K3078. anko LD-K3078 7 páginas. Cordless water kettle

... if you are not going to use it for a prolonged period,

... during thunderstorms and

... before cleaning it.

When doing so, always pull from the plug, not the mains cord.

* Do not use the appliance if the kettle, base or mains cord show any visible sign of damage.

* Do not make any modifications to the appliance and its mains cord or change the connection

cable yourself.

Warning - risk of burns / scalding

* Always place the water kettle on a solid and even surface.

Ensure that it cannot slip or be dropped and that the power cord does not hang down.

* The kettle becomes hot while in use. Do not move the kettle during operation and do not pull

on the mains cord. Only hold/lift the hot kettle by its handle.

* Contact with rising steam can cause scalding! Make sure the lid is always firmly closed and

do not open it while water is boiling or while pouring water out.

* Do not fill the container with less than (0.5 litres) or more than (1.7 litres) of water. If there is

not enough water in the kettle, the appliance may overheat.

* Be sure that the kettle is switched OFF before taking it off the power base.

* The kettle is only to be used with the stand provided.

* If the kettle is overfilled, boiling water maybe ejected.

* The heating element and surfaces are subject to residual heat after use.

* WARNING – Avoid water spillage on the electrical connectors.

* WARNING – Potential injury from misuse.

* WARNING – Do not remove the lid while the water is boiling.

IMPORTANT!

* Take care that any steam escaping from the appliance cannot damage wall paper, wall

cabinets or other items. Turn the spout away from furniture and walls.

* Do not use caustic, aggressive or abrasive cleaning products for cleaning.

Keep hard items away from the appliance.

* Although the kettle is protected from boiling dry, it must never be operated without water.

* If the overheat cut-out switch switches OFF the kettle to prevent overheating and boiling dry,

proceed as follows:

- Take the kettle from the base.

- Allow the kettle to cool down for at least 15 minutes before refilling it with water and replacing

the kettle back on the power base.

* Only use the kettle with the power base provided.

Furniture today is often coated with a wide range of varnishes and plastics and is treated with

various protective substances. Some of these products may contain substances that react

adversely with the rubber feet on the power base, soften them and cause staining on the

surface. Therefore, we recommend placing a non-slip mat under the rubber feet of the kettle.

For cleaning, please refer to CLEANING AND CARE section.