ANLIDAR MYTORQ MY2-TR0210P Manual de funcionamiento y mantenimiento - Página 10

Navegue en línea o descargue pdf Manual de funcionamiento y mantenimiento para Destornillador eléctrico ANLIDAR MYTORQ MY2-TR0210P. ANLIDAR MYTORQ MY2-TR0210P 11 páginas.

Imprimir página

To adjust the torque on these screwdrivers. Proceed as follows :

1. Determine the torque output of the tool by checking a tightened

Fastener with a torque wrench.

2. Increase or decrease the torque by rotating the Spring Adjusting

Ring. Rotating the Ring clockwise to a higher number on the

torque Scale increase torque output while rotating the Ring

counterclockwise to a lower number decreases the torque output.

3. Check the adjustment with a torque wrench. A number of

Factors will affect torque output from one job to another.

Final torque adjustment should be made at the job through a

of series of gradual increase. Always start below the desired

torque and work upward.

4. Adjust the bit torque by changing the driving in length of the

adjust ring at the end.

5. The relationship between torque scale and bit torque is as shown

Ring, in the torque diagram. The figures of torque scale do not

indicate bit torque values. However, the clamping torque of

screw itself is different form type, size, material of the screw and

the material of its mating part. Use it as standard to obtain an

appropriate clamping torque.

6. The (Return torque method) in which once-clamped screw is returned

with torque wrench or the like is available as one of torque control

methods however, note that the measured values by the return torque

method generally appear in 10%~30% lower than the actually clamping

torque.

7. The torque checker measures the torque of screwdriver. The clamping torque of screw itself is different from the clamped

conditions. Understand the correlation between clamping torque values and the torque checker values perform the torque control

properly.

1. Please read the operation manual before you use, and follow safety rules to operate the power controller.

2. The power controller must be used with original MYTORQ 6-pin Electric Screwdrivers.

3. TR0235 Series electric screwdriver collocates with MYP32-300N additional.

4. Also in reverse rotation, the clutch is turned off in such manner as in normal rotation, stopping the motor running. Accordingly,

when the screw tightened at a large torque, set it to a higher torque scale.

5. The number from zero to eight on the Torque Scale are reference number only and not an indication of actual torque output.

6. The power supplier will generate low power when the button of the power controller is switched to "LO." Also, the electric

screwdriver's torque output setting value should be adjusted to middle torsion value accordingly.

7. Please refer to Anlidar website http://www.anlidar.com for the detail component list.

Torque Adjustment Operation

CAUTION