ANLIDAR MYTORQ MY9-0206L Manual de funcionamiento y mantenimiento - Página 10

Navegue en línea o descargue pdf Manual de funcionamiento y mantenimiento para Destornillador eléctrico ANLIDAR MYTORQ MY9-0206L. ANLIDAR MYTORQ MY9-0206L 11 páginas.

Imprimir página

To adjust the torque on these screwdrivers. Proceed as follows :

1. Determine the torque output of the tool by checking a tightened Fastener with a torque wrench.

2. Increase or decrease the torque by rotating the Spring Adjusting Ring. Rotating the Ring clockwise to a higher number on the

torque Scale increase torque output while rotating the Ring counterclockwise to a lower number decreases the torque output.

3. Check the adjustment with a torque wrench. A number of factors will affect torque output from one job to another. Final torque

adjustment should be made at the job through a of series of gradual increase. Always start below the desired torque and work

upward.

4. Adjust the bit torque by changing the driving in length of the adjust ring at the end.

5. The relationship between torque scale and bit torque is as shown Ring, in the torque diagram. The figures of torque scale do not

indicate bit torque values. However, the clamping torque of screw itself is different form type, size, material of the screw and the

material of its mating part. Use it as standard to obtain an appropriate clamping torque.

6. The (Return torque method) in which once-clamped screw is returned with torque wrench or the like is available as one of torque

control methods however, note that the measured values by the return torque method generally appear in 10%~30% lower than

the actually clamping torque.

7. The torque checker measures the torque of screwdriver. The clamping torque of screw itself is different from the clamped

conditions. Understand the correlation between clamping torque values and the torque checker values perform the torque control

properly.

1. Please read the operation caution carefully before using our screwdriver, and follow the safety information to use this power

supplier.

2. This model screwdriver must work with 6PIN power cord assembly and MYP40-1500 power supplier.

3. Turn off the screwdriver before adjusting its torque.

4. If switch the Forward/Reverse switch when the motor is still running, the protection program will be started to stop the motor.

You can restart the screwdriver to use as usual.

5. The torque scale on the screwdriver is for reference only, not the real toque from the screwdriver.

6. The wastage of the screwdriver depends on the torque for using, the using time, and the using frequency by the user. The

attrition rate will be higher under the higher torque for using, the longer using time, and the higher using frequency; A new

screwdriver with the torque scale 4, after 1 month ( 8 hours per day, operate frequency 12PCS per minute ) will lose 3~5%

torque. (lose 5~7% torque with torque scale 8 ). According to the time of using, the wastage will get less and become stable.

User can regular uses the torque meter to measure the torque to adjust the proper torque.

7. If turn to "LO"on the power supplier, the screwdriver can't offer high watt output, the torque on the screwdriver should be

adjust under middle range to use.

8. Please refer to MYTORQ website http://www.anlidar.com for the detail component list.

Torque Adjustment Operation

Attention