AirTest TR9299 Ajuste - Página 2
Navegue en línea o descargue pdf Ajuste para Transmisor AirTest TR9299. AirTest TR9299 2 páginas. Co2 and temperature sensor transmitter
Imprimir página6
Go to the Alarm Tab
Enable the high level alarm by checking the box under the
•
"High" heading.
Set a high level value at which you would like the LED on the
•
Transmitter cover to flash and the Transmitter make an
optional beep. Setting a level of 1500 ppm will allow the alarm
message only if concentrations are unusually high.
Set the time to instant.
•
By activating the high level alarm the red LED on the front
•
cover will flash when elevated levels are detected. The
beeper function can be activated separately using the
instruction below.
Press the "Update" button on the right side of the window. This will update the new alarm settings to
•
the transmitter.
If you are setting multiple sensors in the same way, you can save this setting in Pointview and then
•
upload it to other sensors.
7
Activating the Beep for Alarm Indication.
Disconnect the transmitter from the PC cable.
•
If the sensor is turned on you can press the grey button on the lower right side of the case for about
•
one second. The red LED should flash. This can be used to ensure the unit is powered and the
batteries are working. It will also tell the transmitter to immediately send out a Wifi measurement
broadcast.
To activate the beep, press the grey button and hold for about 5 seconds until the the LED flashes
•
and then the transmitter beeps multiple times. To test hold the button down until the LED flashes
(about 1 second). If you hear the beep when the light flashes the audible alarm feature is activated.
If there is no beep coinsiding with the flas the audible alarm is deactivated.
To deactivate the audible beep, again hold the grey button for about 5 seconds until there are multiple
•
LED flashes and then multiple beeps. old for 5 seconds until you hear multiple beeps.
8
To Test The Audible And Visual Alarm.
Make sure the sensor is turned on and powered by pressing the right grey button once. You should
•
see a LED flash and hear a beep.
Breath into the round sensor on the front of the Transmitter enclosure area approximately every 30
•
seconds.
IN about 2 minutes the LED will start to flash and the transmitter will beep until levels have dropped
•
below the high alarm level previously set.
For Further Information contact:
AirTest Technologies Inc.
1520 Cliveden Ave, Unit 9
Delta, BC V3M 6J8
www.AirTest.com
P: 604 517-3888 TF: 888 855-8880 FX: 604 517-3900
Audible & Visual Alarm Settings for AirTest WiFi Products
Page 2 of 2