DryAIR HRA 6000 Manual del usuario - Página 6
Navegue en línea o descargue pdf Manual del usuario para Herramientas DryAIR HRA 6000. DryAIR HRA 6000 15 páginas.
Imprimir página1.Introduction HRA Hose Reel
Operating Features
*DANGER! It is very important that you read and understand
this manual before operating the reel! Failure to follow the
procedures and cautions in this manual could lead to injury or
possible death! *
The DRYAIR hose reel's primary purpose is dispense and collect
fluid circulation hose on job sites; primarily with respect to
ground thaw and/or concrete cure operations.
The hose reel (see at right in Figure 1-1) includes the following
controls
•
Spool directional controls
•
Momentary foot switch for Load or Unload application.
•
Hose Reel drive speed
•
Degree of drive engagement/braking
Drive Features & Power
Requirements
•
The reel can be run off an 115VAC, 15 Amp circuit.
•
Reel power and directional control is handled through two toggle switches. One controls Power -
On/Off, the other controls the Mode - Load/Unload.
•
The reel motor is a permanent magnet, direct-current, high-torque, 1HP motor capable of variable
speed operation. The reel operates between 5 RPM and 15 RPM. This is adjusted by the MOTOR
SPEED control dial.
•
Drive and motor protection against inertial forces is provided by an adjustable torque-limiter clutch
located between the motor/gear box and the reel spool. An adjustable torque-limiter clutch located
between the motor/gearbox and the reel spool provides additional protection against high inertial
load as well as offering a degree of safety against entanglement.
Electrical Precautions
• Take care to not unplug the unit by pulling on the cord. To
unplug, grasp the plug, not the cord.
*CAUTION! Do not operate unit if the power supply cord or plug
is damaged! Inspect all cords before operating the unit. *
• This appliance is for use on a nominal 120V circuit, and has a
grounding plug that looks like the plug illustrated Sketch A in
Figure 1-2. A temporary adaptor, which looks like the
adaptors illustrated in Sketches B and C, may be used to
connect this plug to a 2-pole receptacle as shown in Sketch B if
a properly grounded outlet is not available. The temporary adaptor should be used only until a
properly grounded outlet can be installed by a qualified electrician. The grounding means (lug,
Introduction HRA Hose Reel
Figure 1-1: Hose Reel
Figure 1-2: Outlet Adapter Use
1-1