Anolis ArcPower 144 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Equipos de iluminación Anolis ArcPower 144. Anolis ArcPower 144 20 páginas.

1. Unplug from the mains before installation.

2. Connect the LED modules to the fixture.

3. Connect DMX controller to the fixture.

4. Connect the fixture to the mains.

5. Set the DMX address on the control board of the fixture (see chapter "Control board").

Warning!

Accidental connection DMX 512 Input/Output to non-DMX 512 device

(e.g.Ethernet network Hub) can demage the ArcPower 144.

Maximum total cable length between one LED zone output of the Arcpower

144 and all its connected LED modules is 80 metres.

Single ArcPower 144 installation:

Multiple ArcPower 144 installation:

Connect the DMX output of

the first ArcPower 144 with

the DMX input of the next

ArcPower 144. Always con-

nect one output with the

input of the next ArcPower

144 until all fixtures are

connected. In this way, up

to 32 fixtures can be chained

together.

At the last ArcPower 144

the data link has to be ter-

minated with a terminator. A

termination plug is simply a

RJ45 connector with a 120 Ω

resistor between pins Data

(–) and Data (+). Plug ter-

minator in the DMX output of

the last ArcPower 144.

Maximum number of LEDs

connected to the one

ArcPower 144 zone is 42,

(but maximum 12 LEDs per

colour).

5. Installing instructions