Anolis ArcWash Recessed 136 RGB Manual del usuario - Página 12

Navegue en línea o descargue pdf Manual del usuario para Equipos de iluminación Anolis ArcWash Recessed 136 RGB. Anolis ArcWash Recessed 136 RGB 19 páginas. Rgb

Imprimir página
The control panel situated on the front panel of the base offers several features. You can simply set the DMX address,
run programs, make a reset and also use many functions for setting the fixture behaviour.
Control elements on the control board:
[MODE] button-leaves menu without saving changes.
[ENTER] button- enters menu,confirms adjusted values and leaves menu.
[UP] button and[DOWN] button- moves between menu items on the the same level, sets values.
After switching the fixture on,the display shows the initial screen:
Use [UP],[DOWN] to browse through the menu. To select a function or submenu,press [ENTER].

7.1 Fixture Address

Use this menu to set the DMX start address of the fixture, which is defined as the first channel from which the ArcWash
136 RGB will respond to the controller.
If you set, for example, the address 15, the ArcWash 136 RGB will use the channel 15 to 28 for control
ted).
Please, be sure that you don't have any overlapping channels in order to control each ArcWash 136 RGB correctly and
independently from any other fixture on the DMX data link.
If two, three or more ArcWash 136 RGB are addressed similarly, they will work similarly.
After having addressed all ArcWash 136 RGB, you may now start operating these via your lighting controller.
Note: After switching on, the ArcWash 136 RGB will automatically detect whether DMX 512 data is received or not.
If there is no data received at the DMX-input, the display will start to flash „A001" with actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the ArcWash 136 RGB.
- the controller is switched off or defective, the cable or connector is defective or the signal wires are swap in the input connector.
Note: It's necessary to insert the XLR termination plug (with 120 Ohm) to the last fixture in the link in order to ensure
proper transmission on the DMX data link.

7.2 Fixture informations

Use this menu to read an useful information about the fixture.
tEMP ---Fixture temperature.The function shows the temperature in the fixture head (°C).Please note that the outside
temperature should not
exceed 40° C.
VErS. --- Software version.Select this function to read the software version of processors:
IC1.b.--- Main processor on the main board in the fixture base
IC2.b.--- Pan/tilt processor on the main board in the fixture base

7.3 Personality

Use this menu to to modify the ArcWash 136 RGB operating behavior.
r.PAn --- Pan reverse.Select this function to invert the pan movement.
r.tilt --- Tilt reverse.Select this function to invert the tilt movement.

7. Functions of the control panel

12
(if Mode 1 is selec-