Drytac HOT PRESS HGP360 Manual del usuario - Página 7
Navegue en línea o descargue pdf Manual del usuario para Herramienta eléctrica Drytac HOT PRESS HGP360. Drytac HOT PRESS HGP360 19 páginas. Heated glass top vacuum press
También para Drytac HOT PRESS HGP360: Manual del usuario (19 páginas)
Imprimir página
crate onto the stand. Align the press with the ends of the
raise lid. Remove three screws at front of diaphragm and draw diaphragm forward by
approximately 300 mm or 12 inches. Working from the underside of the diaphragm, remove the
hose(s) from the fittings in the corners of the diaphragm by pushing the collar on the fittings
inwards while pulling out on the hose. Remove the diaphragm from press. Using the 4 M6 x 80 mm
bolts, 8 M6 penny washers, 4 M6 spring washers and 4 M6 nuts, secure the press to the stand by
passing the bolts up through the holes in the stand ends and into the base of the press. Tighten
these nuts and bolts. Insert the diaphragm back into the press and insert the hoses back into the
fittings on the underside of the diaphragm.
Push the diaphragm back into position ensuring it fits into the three clips at the back of the press
and re-fit the three screws at the front of the diaphragm.
Stand Assembly Instructions for Small Models (HGP220 / 260/ 360)
Component list:
•
2 x leg assemblies
•
2 x top rails
•
2 x bottom rails
•
12 x rail bolts (16 x for 360) M8 x 60 mm dome head
•
4 x press fixing bolts M6 x 80 mm cap head
•
4 x penny washers ¼ x 1 "
•
4 x lock washers M6
•
1 x M6 Allen key
Loosely fit the top rails to the top of the leg assemblies to form a rectangle, using 8 of the M8 x 60
mm bolts. Loosely fit the bottom rails, about half way up the leg assemblies, using the remaining
M8 x 60 bolts. Tighten all bolts using the Allen key and ensure stand is steady. The top rails are
inset from the front and rear, the largest inset is the front of the stand. Lift press onto stand. Fit M6
x 80 mm bolts with lock washers, then with the penny washers, then insert them up through the leg
assemblies into the base of the press. Tighten the bolts (using the Allen key) until rubber press feet
are compressed slightly.
CONNECTING THE VACUUM PUMP
A length of plastic vacuum tubing (either red or green,
depending on the model) is supplied with the equipment.
Connect one end to the pump and the other end to the rear
of the vacuum press. No tools are needed - the tubing is a
simple "push fit" into the special connectors. You will feel
stand. Undo catches at front of press and
7