Anova CC251T Manual de instrucciones - Página 17

Navegue en línea o descargue pdf Manual de instrucciones para Cortacésped Anova CC251T. Anova CC251T 19 páginas.

Imprimir página

CAUTION!Do not drain gasoline in closed spaces, near a fireplace, etc. Do not smoke! Gasoline vapors

can cause explosion or fire.

B) Start the engine and let it run until all the gasoline has been used up.

C) Remove the spark plug. Use an oil container to fill approx. 20 ml of oil in the combustion chamber. Run the

starter motor to evenly distribute the oil in the combustion chamber. Replace spark plug.

2. Carefully clean and oil mower as described under "Lubrication" above.

3. Lightly oil the cutter to prevent corrosion.

4. Store the mower in a dry, clean and frost-protected place, out of reach of unauthorized persons.

CAUTION!Engine must be completely cool before mower is stored.

NOTE:- When storing any type of power equipment in a storage shed without ventilation or material,

- Equipment anti-corrosion precautions should be taken. Using a light oil or silicone, coat the equipment,

especially the cables and all moving parts.

- Be careful not to bend the cables.

- If the starter cable becomes disconnected from the cable guide, disconnect and ground the spark plug

cable. Squeeze the blade control handle and pull the starter cable slowly. Slide the starter cable onto the

cable guide pin on the handle.

Transportation

Shut off the engine and let the engine cool down. Next, disconnect the spark plug wire and drain the fuel tank

according to the instructions in the engine manual. Make sure not to bend or damage the mower when

pushing it over obstacles.

12. TROUBLESHOOTING

ISSUE

The motor does not

start.

Engine starts hard or

loses power.

CAUSE OF THE PROBLEM

The throttle choke is not in the

correct position for the prevailing

conditions.

The fuel tank is empty.

The air filter element is dirty.

Loose spark plug.

Spark plug wire is loose or

disconnected from plug.

Spark plug gap is incorrect.

The spark plug is defective.

The carburetor is flooded with fuel.

Defective ignition module.

Dirt, water or dirty fuel tank.

The vent hole in the fuel tank cap is

plugged.

The air filter is dirty

CORRECTIVE ACTION

Move primer to correct position.

Fill tank with fuel: See ENGINE OWNER'S

MANUAL.

Clean air cleaner element: Refer to ENGINE

OWNER'S MANUAL.

Tighten spark plug: refer to ENGINE OWNER'S

MANUAL

Install the spark plug wire on the spark plug.

Electrode gap adjustment: refer to ENGINE

OWNER'S MANUAL

Install a new properly capped spark plug - refer

to ENGINE OWNER'S MANUAL

Remove the air cleaner element and pull the

starter cable continuously until the carburetor

comes off and install the air cleaner element.

Contact your service representative.

Drain fuel and clean tank. Fill the tank with

clean, fresh fuel.

Clean or replace fuel tank cap.

Clean the air filter.