Anova TP2502 Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Herramienta eléctrica Anova TP2502. Anova TP2502 12 páginas. Battery pruning shears

7. Replace the blade8. Insert the nut9. Install the lock nut

Support blade and moving blade can be replaced independently; As a replacement, don't worry

about too small a blade opening; after recovering the power of the scissor, the normal opening size will

recover automatically.

4. Maintenance

4.1 Scissor maintenance

1. Do not cut branches outside the cutting range; do not cut non-vegetable materials, such as metals and

stones, etc. do not use clamps or the like to hold the scissors; Always replace the cutting blade if it is

worn or damaged.

2. Keep the cutting equipment clean, clean the scissors, batteries and charger with a clean cloth (do not

use corrosive detergents!) and a soft brush or dry cloth to clean the dust on the upper scissors.

3. Do not immerse the scissors, batteries and charger in water or other liquids;

4. Use the equipment correctly; Stop using it when there is damage to the scissor, batteries and/or

chargers.

5. If the switch can't turn the scissor on or off, please don't use the scissor. It will be dangerous to control

the scissor without the switch properly. Always replace and repair the switch in this case before using the

scissors again.

6. Make sure the switch keeps the pruning shears off when you replace accessories or store the pruning

shears. Such preventive measure will reduce the risk of accidentally activating the scissors and causing

injury to the user.

7. Turn off the pruning shears if you are not going to use it and store it out of the reach of children. It is

dangerous to allow inexperienced people and untrained users to operate the pruning shears.

8. When using pruning shears, respect the tool and the specific use for which it was designed. Consider

the work environment and the tasks to be performed; It can cause risk and damage by using improperly

working pruning shears.

9. After using it, please remove the dirt on the moving blade and the supporting blade, add lubricating oil

or engine oil on the contact part, make the blade keep in good sharpness to extend its service life and to

future uses.

4.2 Battery maintenance

1. Use the battery as the only valid power source for your electric pruning shears. Do not use the

battery as a power source for any other power tool not listed.

2. Do not charge the battery in temperatures below 0ºC or above 45ºC; this can damage the battery

and charger.

3. Make sure the battery switch is off before connecting the power cable; if it is open it can create a

problem when connecting to the scissors.

4. Use only the charger assigned by the manufacturer to charge the battery; It may cause battery fire

or explosion if you use chargers with inadequate power.