DS Services of America 300m Series Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Dispensador de agua DS Services of America 300m Series. DS Services of America 300m Series 7 páginas. Pure water dispenser

Imprimir página

CHILD SAFETY

CAUTION:

Supervise children when using the dispenser.

The hot dispenser faucet is equipped with a child

safeguard that reduces the risk of hot water being

dispensed accidentally or by small children. To dispense

hot water, simultaneously depress the child safety lock

(located above the left hot faucet handle) and the left

hot faucet handle. Do not allow children to hang, climb

or stand on the dispenser; the dispenser could fall over

and the child could be injured.

RECEIVING

Inspect the dispenser box carefully for any evidence of shipping or handling damage before signing to receive goods.

In case of shipping damage, claims should be filed immediately with the carrier.

HOW TO INSTALL AND USE

WARNING:

Read through every step in HOW TO INSTALL AND USE before plugging in

or turning unit on.

1. Keep dispenser unplugged and in the off position until the water bottle has been loaded and water flows through the faucet.

2. Ensure dispenser stands upright for a minimum of 2 hours before loading water bottle, plugging in and turning on dispenser.

3. Place dispenser a minimum of 2 inches away from the wall to ensure ventilation.

4. Install dispenser on a level floor strong enough to support it when fully loaded.

5. Do not install dispenser where it will be subject to direct sunlight, heat or moisture.

6. Do not install dispenser where the temperature will go below 50° F (10° C) or above 100° F (38° C).

7. Wipe down the water bottle cap and neck to ensure there is no debris.

8. Remove tamper-evident seal from plastic bottle

cap. Do NOT remove plastic cap if using a NO-SPILL

water bottle.

NOTE:

Be sure to use a NO-SPILL water bottle.

Using bottles without the NO-SPILL feature can

cause leaking to occur.

9. Ensure the No Leak® EZ-Fill® system is fully seated.

10. Load water bottle by lifting and inserting it onto

the probe, ensuring bottle is fully aligned with the

dispenser and centered over the probe. Be certain

fingers and other body parts are clear of underside

of bottle. Apply slight pressure until the plug inside

the cap pushes in and the bottle is seated. Water

will begin to flow into the tank causing air

bubbles in the bottle.