DS Services of America Pure Water Dispenser 300m Series Manual de configuración rápida - Página 2
Navegue en línea o descargue pdf Manual de configuración rápida para Dispensador de agua DS Services of America Pure Water Dispenser 300m Series. DS Services of America Pure Water Dispenser 300m Series 2 páginas. Pure water dispenser
También para DS Services of America Pure Water Dispenser 300m Series: Cómo limpiar (2 páginas)
Imprimir páginaRead all directions before plugging in dispenser.
1
Important: Do not plug in dispenser until step 5.
This guide is a general reference to help you quickly and easily set
up your Pure Water Dispenser™ 300m Series. For complete setup,
operating and safety instructions, reference the owner's manual.
Place dispenser on level floor surface at least
2
2 inches from wall.
Insert bottle and fill dispenser with water
3
PRIOR to plugging in.
Remove tamper-evident seal from plastic bottle cap.
(Do NOT remove plastic cap if using a NO-SPILL water bottle.)
Load water bottle by lifting and inserting it onto probe. Be sure
bottle is fully aligned with dispenser, centered over probe and
fingers or other body parts are clear of underside of bottle.
Apply slight pressure until plug pushes in and bottle is securely
seated. Water will flow into the tank causing air bubbles.
Purge water tanks.
4
Place cup under HOT dispenser nozzle, lift red lever and pull out
handle until HOT tank is full and one cup of water has been
dispensed. Repeat this step for the COLD water tank.
5
Plug in dispenser to a GFCI outlet.
6
Turn on heater switch.
Turn on hot tank heater using switch located on rear of dispenser.
Water will become hot in approximately 1 hour. Red light will go
off when hot tank reaches operating temperature.