DS18 GEN-X212LD Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Subwoofer DS18 GEN-X212LD. DS18 GEN-X212LD 6 páginas. 2x12" subwoofer in a ported box

Imprimir página

INSTALLATION INSTRUCTIONS

Professional
installation
authorized
DS18
recommended!
performance of your new gear may not
be satisfactory. In the event
that you decide to do your own
installation, please read and follow this
manual carefully.
Failure to do so may compromise the
integrity
of
this
automobile, and possibly void the
product warranty.
Use this Subwoofer Box with an external
Monoblock subwoofer amplifier that
can handle 1 ohm load impedance and a
maximum of 900W RMS continuous
power, otherwise the amplifier or the
Subwoofer can get damaged.
In case that you need to install an
amplifier please refer to the amplifier's
instruction manual to perform the
installation of the amplifier before the
use this Subwoofer Box.
Do Not Connect this directly to the
factory radio or aftermarket radio
speaker output. This will not be enough
power for the subwoofers and could be
bad for the radio's amplifier if is not 1
ohm stable.
Secure the subwoofer box with a strap
or bracket to screw it down in case this
box is loose on your trunk or a SUV
4
by
an
dealer
is
highly
Otherwise,
the
product,
your
cargo area to avoid this moving around
which will damage the Subwoofer or box
itself. In case of accelerating or hard
braking this will reduce the possibility of
movement! Major injuries may occur in
case of an accident if this is not secured
properly.
If you already have installed
the amplifier then follow these
simple steps:
1
Connect the subwoofer box to the
amplifier
using
speaker wire and make sure the polarity
(+) and (-) is correct, otherwise the
sound will be affected.
2
You are now ready to play it for the
first time. It is best to leave the gain all
the
way down in the beginning. Start with a
low volume and work your way up.
3
Now you can tune the amp. We
recommend using the Low Pass Filter at
120Hz or lower depending on your
system. Take your time and make only
one adjustment at a time. It may take
some time to get the system fully
adjusted. During this time the amp is
drawing current from the battery. You
should check the battery voltage from
time to time and re-charge it if it gets
low. That's it! You are done.
Now have fun!!
a
minimum
12Ga