Daintree GE Current Lumination 22 Series Manual de instalación - Página 3

Navegue en línea o descargue pdf Manual de instalación para Linterna Daintree GE Current Lumination 22 Series. Daintree GE Current Lumination 22 Series 3 páginas. Led 120-277v

Imprimir página

Installation

Remove electrical enclosure cover. Remove knock-

out for AC line input wires.

Install listed electrical fittings in the knockout holes

for wire protection. Connect the dimming controls

(grey and purple or purple and purple/white, one

set for UV one set for WHITE) wires of the LED

drivers using 18-14AWG twist-on wire connectors.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interfer-

ence, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-005 (A(A) NMB-005

(A)

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own expense.

Note: CONTACT FACTORY for details and limitations when seeking to incorporate this product with an emergency system other than Battery Backup.

www.gecurrent.com

General Electric Company and are used under license. Information provided is subject to change without

notice. All values are design or typical values when measured under laboratory conditions.

IND553 (Rev 01/15/20) A-1024174 Rev 01

Install listed electrical fittings in the knockout holes for

wire protection. Connect the AC lines (UV and WHITE)

to the luminaire internal wires according to the wiring

diagrams using 18-14AWG twist-on wire connectors.

Replace electrical enclosure cover and secure it

with the screw.