Ansel 2012 Manual de inicio rápido - Página 2

Navegue en línea o descargue pdf Manual de inicio rápido para Punto de acceso inalámbrico Ansel 2012. Ansel 2012 2 páginas. Client bridge

Imprimir página
Wireless Access Point, Client Bridge
2.
Name: Specify a user name into the first
field.
3.
Password: Specify a password into this
field and then re-type the password into
the Confirm Password field. Then click on
the Apply button.
4.
Click on the Apply button to save the
changes.

System Properties

1.
Click on the System Properties link on the
System section. This feature allows you
to configure the device as an Access
Point or Client Bridge.
2.
Device Name: Specify a name for the
device – this is not the SSID.
3.
Country/Region: Select the region from
the drop-down list.
4.
Operation Mode: Select Client Bridge,
Access Point, Client Router, WDS Bridge
radio button.
5.
Click on the Apply button to save the
changes.
IP Settings
1.
Click on the IP Settings link on the
System section. This feature allows you
to configure the LAN interface using a
static IP address or as a DHCP client.
This IP address is also used to access
the web-based interface.
2.
IP Network Setting: Select Obtain an IP
address automatically (DHCP) radio
button if the Access Point is connected to
a DHCP server. This will allow the Access
Point to pass IP addresses to the clients
associated with it. Or you may select
Specify an IP Address radio button if you
would like the device to use a static IP
address. In this case, you would be
required to specify an IP address, subnet
mask, default Gateway IP address and
DNS.
3.
IP Address: Specify an IP address
4.
IP Subnet Mask: Specify the subnet mask
for the IP address
5.
Default Gateway: Specify the IP address
of the default gateway.
6.
DNS: Specify the IP address of the DNS.
7.
Click on the Apply button to save the
changes.
Note: If you change the IP address here, you may
need to adjust your PC's network settings to
access the network again.
Wireless Network & Security
1.
Click on the Wireless Network link on the
Wireless section. This feature allows you
to configure the wireless mode, channel,
SSID, and security settings.
2.
Wireless Mode: Depending on the type of
wireless clients that are connected to the
network, you may select A, B, G, B/G-
mixed.
3.
Channel: Select a channel from the drop-
down list. The channels are based on the
country's regulation.
4.
You may configure up to four different
wireless profiles. Click on the Edit button
to modify the profile and place a check in
the Enable box to activate the profile.
5.
SSID: The SSID is named shared
amongst all the points of the wireless
network. The SSID cannot exceed 32
characters.
6.
VLAN ID: If you have enabled VLAN
tagging on your network, specify the
VLAN tag ID.
7.
Suppressed SSID: Place a check in this
box if you would like to hide the SSID. By
enabling this feature, wireless clients will
not be able to watch the SSID of this
access point in a site survey.
8.
Station Separator: This is also known as
layer 2 isolation. Clients connected to this
Access Point will not be able to directly
communicate with each other.
9.
Security Mode: By default, the security is
disabled. Refer to the user's Manual to
configure the security features such as
WEP, WPA, WPA-PSK, WPA2, WPA2-
PSK, WPA-Mixed and WPA-PSK Mixed.
10. Click on the Apply button to save the
changes.