Foxconn R10-D1 Manual

Navegue en línea o descargue pdf Manual para Escritorio Foxconn R10-D1. Foxconn R10-D1 2 páginas. Easyguide.

Imprimir página

R10-D1

�PECI�ICATION

M/B Configuration

Mini ITX MB

�imension (W/�/�)

95*280*282mm (W/O Bezel)

1*5.25" External

�rive Bays

1*3.5" External (�hort)

1*3.5" Internal

2*U�B2.0

�ront I/O Ports

1* Micphone,

1* Earphone

�P�

��P150-50GLT

�an

80*80*20mm

WEEE:

The use of this symbol indicates that this product may not be treated as household waste. By ensurin� this product

is disposed of correctly, you will help prevent potential ne�ative consequences for the environment and human

health, which could otherwise be caused by inappropriate waste handlin� of this product. �or more detailed

information about recycling of this product, please contact your local city office, your household waste disposal

service or the shop where you purchased this product.

All image are for reference only, please refer to the physical chassis for specific features.

P/N:3A2512�00-G8W-G

:3A2512�00-G8W-G

Bezel View

Rear Panel View

Open the case

1. Take the chassis out of its packin�.

2. Remove the top cover screw on the

Remove the top cover screw on the

real panel.

Top cover (or �ide Panel)

Top cover

�ront

Panel

Remove Bezel and Driver Bay

1. Release four clips on the bezel top.

2. �old the bezel with both hands, lift

left hand side to release two bottom

clips.

5. Remove two screws to detach

6. Push driver bay toward real panel and lift it

the driver bay.

to remove.

Install Memory

1. �pread the clips at both ends of the

�pread the clips at both ends of the

2. Memory module has asymmetric pin

memory socket.

counts in its two sides separated by a

notch in the middle, so it can only fit in

one direction.

Install Hard Disk Drive (HDD)

1. Put the �� into the chassis as depicted

Put the �� into the chassis as depicted

2. Move the �� to ali�n with three

ove the �� to ali�n with three

in the picture.

screw holes.

5. Connect power cable to ��.

3. Remove the top cover by pushin� it toward

4. Check there are motherboard, power

real panel, and lift it.

supply and driver bay inside.

3. Lift ri�ht hand side to release another

4. �etach the card reader cable from

bottom clip.

the motherboard.

7. Now, you can start the installations of

memory, hard drive and optical disk drive.

3. Place the memory module onto the

4. The clips at both ends of the socket will

socket, then push it down firmly and

snap into place when the memory module

seat it vertically into the memory

is securely inserted.

socket.

3. �asten the �� with three screws.

�asten the �� with three screws.

4. Use provided shorter �ATA cable to

connect motherboard and ��.