DSC PC3000RK Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Sistema de seguridad DSC PC3000RK. DSC PC3000RK 15 páginas.

Disarming

Enter the premises only through the door indicated by your installer as the entry

door. The keypad sounder will be ON. Go to the keypad and enter the [4 digit

access code]. If an error is made entering the code, press the [#] key and enter the

code again. The "Armed" light will go out and the keypad sounder will stop. The

correct access code must be entered before the allowed entry time expires. The

entry delay time may be changed by the installer.

If an alarm occurred while the panel was armed, the "Memory" light and the light for

the zone which caused the alarm will start to flash and will continue flashing for 2

minutes. At the end of 2 minutes, the keypad lights will stop flashing and the keypad

will return to the normal Ready condition.

If you return home and find an alarm has occurred while you were away, it is possible

that an intruder may still be on the premises. Go to a neighbour's and if your system

is monitored, call the monitoring station. They will advise what action has been

taken as a result of the alarm and whether the premises are safe to enter. If your

system is not monitored, call the local police to investigate.

If the "Memory" light is on, an alarm has occurred since the last time the panel was

armed. The alarm memory will automatically be displayed when the system is

disarmed (see Disarming).

Press the [

] then [3] keys to display which zone caused the alarm.

The alarm memory will be cleared when the panel is re-armed.

Press [#] to return to Ready.

Bypassed zones do not cause an alarm. Use zone bypassing when access is

needed to part of the protected area. Also, damaged wiring or contacts on a zone

may be temporarily bypassed until repairs can be made so that the panel can be

armed.

To bypass zones, enter [

for zone 1, [1][6] for zone 16. If the [0] key is pressed twice instead of a zone number,

all zone bypasses will be removed. If the [9] key is pressed twice, the last group

of zones which was bypassed will be recalled. Press [#] to return to Ready.

For security reasons, your installer may prevent the bypass command from

operating on certain zones.

The "Bypass" light is ON as long as at least one zone is bypassed. Do not

unintentionally bypass zones when arming. Zone bypasses are automatically

cancelled each time the panel is disarmed and must be re-applied before the next

arming.

],[1] and the zone numbers to be bypassed. i.e. [0][1]