DAITEM SH401AX Manual de instalación - Página 2
Navegue en línea o descargue pdf Manual de instalación para Sistema de seguridad DAITEM SH401AX. DAITEM SH401AX 9 páginas. Indoor siren
Imprimir página1. Introduction
IMPORTANT
• Some functions are only available with versions 2.0.0 or later (press
check the version).
• The operating differences with former ranges are described in the compatibility booklet available in the Daitem installers
section at www.daitem.co.uk.
In addition to the protection provided by the control panel with built-in siren and keypad, the indoor siren deters intruders.
If a fire is detected, the siren is triggered for 5 minutes in fire sounding mode.
Thanks to its built-in transmitter, the siren informs the control panel when it has a battery problem.
If somebody attempts to pull the siren off the wall, it sounds and then triggers all the alerts and deterrents via the control
panel.
2. Preparing the siren
2.1 Tooling required
2.2 Opening the siren and connecting the power supply
1. Insert a screwdriver in the bottom-
right hand corner between the base
and the siren and apply pressure to
open
the
siren.
3. Position the power pack on the
guide rails.
4. Slide the power pack downwards
until it is locked into place.
Unlocking key
To remove the lithium power pack, press on the unlocking key and slide the pack upwards.
IMPORTANT
• When the siren is powered, it will issue a long beep and automatically switch to installation mode (tamper mechanism
disabled).
• If the siren does not respond as it should: - disconnect the power pack,
6 mm
PZ 2
2. Place the siren on a flat surface, remove the base by inclining
it at a 45° angle (A) and pull it downwards (B).
A
45°
- wait for 2 minutes,
- reconnect the lithium power pack,
- check the siren issues a long beep as it should.
IMPORTANT: the fixing screws
and wall plugs are not supplied.
5. Guarantee sticker
SH401AX
Remove the pre-cut part of the sticker and
A12260A0963C
SH401AX
Coller sur certif
A12260A0963C
stick it to the guarantee certificate in the
user manual supplied with the control
panel. If you are adding the siren to an
existing system, use the guarantee sticker
provided with this product.
SH401AX
A12260A0963C
SH401AX
Coller sur certif
A12260A0963C
2
on the control panel keypad to
B