DAITEM SH148AX Manual de instalación - Página 14

Navegue en línea o descargue pdf Manual de instalación para Sensores de seguridad DAITEM SH148AX. DAITEM SH148AX 18 páginas. Outdoor ir anti-masking 5 m

Imprimir página

9.1 Fault indications

The control panel responds to detector

battery faults, tamper faults, radio faults and

anti-masking faults.

• Battery fault: following a system

command, the control panel issues the

voice message "Beep, fault, battery,

detector X".

• Tamper fault: following a system

command, the control panel issues the

voice message "Beep, fault, tamper,

detector X".

This fault is caused by the radio box not

being properly closed on the base or by

the front panel not being properly closed

on the detection module.

• Radio fault: following a system command,

the control panel issues the voice message

"Beep, fault, radio, detector X".

• Masking fault: when the front panel has

been masked for roughly 3 minutes and

following an arming command, the control

panel issues the voice message "Beep,

exit X open" or "Beep, armed, exit X open".

N.B.: a deposit of frost on the upper and

lower lens composes an opaque surface

that may have the effect of masking the

front panel.

9.2 Changing the battery

IMPORTANT: the detector's parameters are saved when the battery is changed.

1. Put the control panel in installation mode by asking the user to enter:

master code

2. Open the detector box (see § 2. Opening the detector).

3. Replace the ﬂat lithium battery.

4. Put the control panel back in user mode by entering:

installer code

5. Perform a real test (see § 8. Performing a real test).

• It is essential to replace the lithium battery supplied with the same type of lithium battery offering

the same characteristics (3.6 V - 4 Ah).

• We advise you to use a DAITEM brand BatLi25 battery available in the catalogue in order

to guarantee individual safety and equipment reliability.

• Dispose of the flat lithium battery in the appropriate recycling bin.

then

installer code