DAITEM SH274AX Manual de instalación - Página 4

Navegue en línea o descargue pdf Manual de instalación para Sensores de seguridad DAITEM SH274AX. DAITEM SH274AX 4 páginas. Contact detector
También para DAITEM SH274AX: Manual de instalación (13 páginas)

Imprimir página

To test the detector:

• press the test button and the detector changes to test mode for about 90 sec.

After this period the detector automatically returns to normal operating mode,

• check detection of protected entrance opening and closing:

- entrance open: the test LED indicator lamp lights up,

- entrance closed: the test LED indicator lamp goes out.

Pressing on the button for more than 1 sec. causes the control panel to give a

"Test" message when the panel is in test or installation mode.

6. Maintenance

6.1 Battery low indication

The control panel indicates when the contact detector's battery is low.

To check whether there is a problem with the detector battery, press on the detector's test button.

IMPORTANT: if the test LED indicator lamp no longer lights up, the lithium battery should be replaced.

6.2 Changing the battery

• The lithium battery pack must be replaced by the same type of pack with the same technical characteristics

(BatLi31 3 V - 1 Ah).

• We advise you to use the DAITEM BatLi31 pack available in the catalogue in order to guarantee individual

safety and equipment reliability.

• Dispose of the waste lithium power pack in an appropriate recycling bin.

To change the battery:

1. Switch the control panel to installation mode and ask the master user to press:

master code

The detector's conﬁguration is saved when the battery is changed.

2. Open the detector casing (see § on Opening).

3. Unclip the lithium battery pack.

4. Wait 2 min. before replacing the ﬂat lithium battery.

5. Close the detector.

6. Switch the control panel back to user mode. Press:

engineer

installer code

7. Technical data

Speciﬁcations

Built-in magnetic contact

Environment

Power supply

Battery life

Average humidity rate

Radio links

Test button

LED Indicator lamp

Operating temperature

Anti-tamper & protection

Degrees of mechanical

protection

Dimensions L x W x H

Weight (with battery)

then

engineer

installer code

"beep, date,

time, off"

Contact detector

building interior

DAITEM 3 V lithium battery (BatLi 31)

5 years in normal conditions of use

5% to 75% without condensation at 25°C

TwinBand

400/800 MHz

programming, battery and detection test

-10 °C to +55 °C

• against opening and removal

• against loop cutting

IP 31/IK 04

108 x 26 x 30 mm

60 g

"beep, installation

mode"

DECLARATION OF CONFORMITY

Manufacturer: Hager Security SAS

Address: F-38926 Crolles Cedex - France

Product type: Contact detector

Trade mark: Daitem

We declare under our sole responsibility that the product to which this

declaration relates is compliant with the essential requirements of the

following directives:

• R&TTE Directive: 99/5/EEC

• Low voltage directive: 2006/95/EC

• Directive ROHS: 2002/95/EC

in compliance with the following harmonised European standards:

Products code

EN 300 220-2 V2.3.1

EN 55022 & 55024 (2002)

EN 50130-4 (95) + A1 (98) + A2 (2002)

EN 60950 (2006)

EN 301 489-1 V1.8.1

This product can be used in all EU, EEA Countries and Switzerland.

Crolles, 02.01.2013

Signature: Patrick Bernard

Director of Research and Development

Non-contractual document, may be modified without prior

notice.

SH273AX

SH274AX