DSC PowerSeries RFK5516 Manual de instrucciones - Página 12

Navegue en línea o descargue pdf Manual de instrucciones para Sistema de seguridad DSC PowerSeries RFK5516. DSC PowerSeries RFK5516 20 páginas. Power pk55xx/rfk55xx-433 series
También para DSC PowerSeries RFK5516: Manual de instrucciones de instalación (9 páginas)

DSC PowerSeries RFK5516 Manual de instrucciones

Bell Squawk Attribute

This attribute is used to determine whether an access code should generate an arming/disarming Bell
Squawk upon entry of the code for Away arming. The Wireless Keys with access codes associated
with them may generate Arming/Disarming Bell squawks. If desired, this option may be used with
codes that are manually entered. Please contact your installer to have this programmed.
NOTE: The Master Code cannot use the Bell Squawk attribute, but is required to enable it for other
codes.
NOTE: This feature cannot prevent the Arm/Disarming squawks from being generated if an access
code assigned to a WLS Key is manually entered at a keypad.

Partition Assignment Mask

In order to accommodate Access Code Partition Assignment for the multiple partitions found on this
product the user must enter [,][5][Master or Supervisor Code][98][Code number to be change] (ex.
[,][5][1234][98][Code 03]. Under this section, each bit represents the corresponding partition's
access (i.e. Bit 4 represents Partition 4 access).
The Master Code has access to all partitions, and cannot be modified.
Partition Assignment Mask ([
1. Partition One Access
2. Partition Two Access
3. Partition Three Access
4. Partition Four Access
5. Partition Five Access
6. Partition Six Access
7. Partition Seven Access
8. Partition Eight Access
Notes on Access Codes and Programming
1. - [,][5][MASTER CODE] [01 to 48] to program access codes
- [,][5][MASTER CODE][98] enters the Partition Assignment Mode [01 to 39 and 41 to 48] to edit
access code partition assignments
- [,][5][MASTER CODE][99] Enters the Attribute Mode. To edit access code Attributes.
2. The Master Code's attributes cannot be changed.
3. When a new code is programmed in
tem. If a duplicate code is found, an error tone is given and the code is returned to what it was
before it was changed. This applies to both 4 and 6-digit codes.

Erasing an Access Code

To erase a code, select the code and enter
delete the code immediately and the user will be returned to select another code.

User Function Commands

First disarm the system then enter
The
command is used to gain access to the following list of Master functions of the system.
[1] Time and Date
Enter 4 digits for 24 Hour System Time (HH-MM). Valid entries are 00-23 for the hour and 00-59 for
minutes.
Enter 6 digits for the Month, Day and Year (MM-DD-YY)
[2] Auto-arm/Disarm Control
Pressing [2] while in the User Function menu will enable (3 beeps) or disable (one long beep) the Auto-
arm and Auto-Disarm feature, by partition. With this feature enabled, the panel will automatically arm
in Away mode (Stay Away zones active) or disarm at the same time each day. The auto-arm time is pro-
grammed with the [,][6][Master Code][3] command. Auto-Disarm must be programmed by the system
installer.
,
][5][Master/Supervisor Code][98][Code])
it will be checked against all other codes in the sys-
as the first digit. If
[Master Code]
10
is entered, the system will