Anslut 002-282 Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Luz exterior Anslut 002-282. Anslut 002-282 11 páginas. Wall lamp

Imprimir página
EN

SAFETY INSTRUCTIONS

•
Only intended for outdoor use.
•
The LED light source is not replaceable.
When the light source has reached the
end of its useful life the complete lamp
must be replaced.
•
The electrical installation must comply
with local regulations. Consult an
authorised electrician if in doubt.
•
Always follow the electrical specifications
on the product labelling.
•
Always disconnect the power supply
before installation, connection and
service.
•
Never modify the lamp, this could result in
serious personal injury and will invalidate
the warranty.
•
The lamp must be connected to an
earthed power supply for installation.
ELECTRICAL SAFETY
New installations and extensions to existing
systems should always be carried out by
an authorised electrician. If you know how
(otherwise contact an electrician), you
can replace switches and power points, fit
plugs, extension cords and sockets. Incorrect
installation can result in fatal injury and the
risk of fire.
Symbols
The product must be connected
to an earthed power supply.
Approved as per applicable
directives.
Recycle discarded product
in accordance with local
regulations.
10

TECHNICAL DATA

Rated voltage
Output
Luminous flux
Colour temperature
Life span
Off/On
Energy class
Protection rating
Diffusion angle
Overall size

INSTALLATION

NOTE:
•
Always disconnect the power supply
before installation.
•
The lamp is for wall mounting.
1.
Remove the lamp from the metal casing.
2.
Unscrew the socket head screw holding
the lamp unit to the base plate.
FIG. 1
3.
Mark out where the base plate is to be
mounted.
4.
Drill holes for the screws holding the
base plate.
5.
Screw the base plate to the wall.
Use plugs if necessary.
6.
Connect the power cables to the terminal
block on the lamp. Connect the correct
cables to N, L and .
FIG. 2
7.
Place the lamp on the base plate. Tighten
the screws to fasten it to the base place.
8.
Slide the metal casing over the lamp.
FIG. 3
9.
Switch on the power supply.
230 V ~ 50 Hz
6 W
480 lm
3000 K
30000 h
10000 times
A
IP54
95°
100 x 100 x 100 mm