Anslut 411-122 Instrucciones de uso - Página 14

Navegue en línea o descargue pdf Instrucciones de uso para Calentador Anslut 411-122. Anslut 411-122 15 páginas. Convector heater

Anslut 411-122 Instrucciones de uso
Assembly (portable for use of floor)
Fit the feet before using the appliance (supplied unfitted in box). The feet must be fitted on the underside
of the appliance with the 2 self-tapping screws. Make sure they are correctly positioned at each end.
Read the User Instructions carefully before use.
Save these instructions for future reference.
NOTE: The appliance may emit a slight smell or fumes the first time it is switch on, or if it has not been
used for some time. This is normal.
Set the required temperature
1.
Put the appliance in a suitable place, with due consideration to the above safety instructions.
2.
Plug the power cord into a suitable mains outlet.
3.
Turn the thermostat control to max.
4.
Switch on the fan. Lamp 2 goes on when the appliance is switched on. For maximum heating, turn
the selector to position 3.
5.
When the desired room temperature has been reached, slowly turn the thermostat knob until you
hear a click and the light goes out. The appliance will then switch on and off automatically to maintain
a constant room temperature.
6.
If you do not want to heat up the room as quickly, turn the output selector to I or II. Start the fan to
increase the circulation of heat. The fan only works if the output selector is in position I-III.
The heater has a thermal cut-out that trips if the appliance overheats. If the cut-out trips, disconnect the
heater from the wall socket and allow to cool for 5 minutes. Investigate the cause of the overheating before
connecting the heater to the wall socket again.
Jula reserves the right to make changes. In the event of problems, please contact our service department.
www.jula.com
ENGLISH

INSTALLATION

OPERATION

14