Daiwa USJ-9050 Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Masaje Daiwa USJ-9050. Daiwa USJ-9050 12 páginas. Massage lounger

SETUP

6. Installing the back cushion and buffering cushion

Affix the back cushion and buffering cushion to the backrest of the chair with zipper.

To install the heater onto the back cushion, locate the connections on the pillow and

the waist air tube (see illustration below).

Use tape to fasten the lower portion of the back cushion to the seat cushion.

Zipper

Plug of the heater

7. Installing the seat cushion

Place the seat cushion onto the seat shelf, and attach the air tube connector.

Use tape to fasten the seat cushion to the seat shelf.

8. Other connections

Locate the cord attached to the controller and connect it to its corresponding port on

the power supply box.

Place the controller onto the tray.

Insert the power plug of the chair into a wall outlet, then turn on power to return the

chair's backrest to its upright position.

Air tube connector

Air tube

SETUP

MOVE METHOD

Make sure that the backrest is in its highest upright position.

Shut off power and remove the power plug from the wall outlet.

Standing behind the back of the chair, grasp its backrest and tilt it downward, so

that the front of the chair rises off of the floor. Push the chair to the location you

desire.

CAUTION

Do not attempt to move the chair while someone is still sitting on it.

While moving the chair, always grasp its backrest. No not try to move the chair by

grasping its armrests.

Before plugging it in, inspect the entire power cord and plug for any possible

damage. Make sure that no electrical wires are exposed.

Make sure that the power supply switch is turned OFF before inserting the power

plug into a wall outlet.