ATS Diesel Performance Aurora Plus - 5000 Manual de instalación - Página 11
Navegue en línea o descargue pdf Manual de instalación para Accesorios para automóviles ATS Diesel Performance Aurora Plus - 5000. ATS Diesel Performance Aurora Plus - 5000 18 páginas. Aurora plus - 5000 turbo kit (2003-2007) 5.9l dodge
Imprimir páginathe best clearance for a wrench in this location. Install this nut first by
holding the turbo just off and while turning the nut lower the turbo onto the
studs. Install the three serrated flange hex nuts and use three more
serrated washers. Tighten all four in a crisscross pattern.
Alignment Pin Holes
4. Modify the factory exhaust-manifold-heat-shield by trimming off the
section behind the first two sets of manifold bolts so that it can be
reinstalled with the ATS exhaust manifold.
5. Install the ATS manifold and factory turbo assembly onto the engine block
using the six gaskets provided (Figure 1, #28) in the kit and the trimmed
heat-shield.
6. Install the compound exhaust elbow (Figure 1, #12) onto the factory turbo.
Align the pins on the exhaust elbow with the holes on the factory turbo.
Use the supplied 4" v-band clamp (Figure 1, #19) to secure the exhaust
elbow in place.
7. Once the exhaust elbow is in place, use (4) flange hex nuts, (4) serrated
washers, and the gasket supplied (Figure 1, #28) in the kit to connect the
Aurora 5000 turbo to the exhaust elbow. Use a small amount of heavy
grease to hold the gasket in place while lifting the Aurora 5000 up to the
exhaust elbow.
8. Use the three supplied 8mm hex flange bolts to attach the supplied heat
shield (Figure 1, #8) to the rear of the exhaust elbow.
Inner-Rear Hole
Alignment Pins
Installed
Inner-Rear Nut