DSPPA MAG68 Series Manual - Página 4

Navegue en línea o descargue pdf Manual para Amplificador DSPPA MAG68 Series. DSPPA MAG68 Series 5 páginas. 1u ip network amplifier

Imprimir página
DSPPA MAG68 Series Manual
Front / Rear Panel
Front Panel
1
1.
Mounting Holes
2.
Power Switch
3.
Signal LED
 Power: Power LED. It will be on when powered
on and turned on.
1
 Net Service: Net LED. It will be on when the
machine is connected to the host successfully.
 Timing: Timing point LED. The amplifier can
execute the edited timing points on the host
when separated from the host. The LED will be
on when the terminal is able to perform the
timing points without the host.
 Signal: Amplifier output level LED. It will be on
when the amplifier has signal output, and it will
turn brighter when the volume increases and
darker when the volume decreases.
 CILP: CLIP LED. It will be on when the output
signal is too large.
 PROT: Protection LED. It will be on when there is
over current, over heat or short circuit in the
amplifier.
4.
Digital Display Screen and IR Remote Receiving
Window
The digital display screen shows the working status of
the machine and the status of network information.
The infrared remote receiving window is embedded in
the lower left corner of the display screen, and it can
bring the machine under control with the infrared
remote controller.
5.
"USB" Button
 USB Play/Stop Button; press the button to exit
the setting status when setting the IP.
/
电源
2
电源
2
www.dsppatech.com
Power
MAG6806
Net Service
Timing
Signal
CLIP
Public Address Network Amplifier
PROT
3
4
6.
"F1" Button
 Used to switch among AUX IN, MIC IN and MP3
when adjusting the volume.
AVP8406
Power
7.
"Set" Button
Net Service
Timing
Signal
CLIP
 Set button. Long press the button to enter the IP
Public Address Network Amplifier
PROT
checking status, and press again to enter the IP
setting status.
3
4
"VOL-" Button
8.
 Used to turn down the volume in the play mode;
used to switch parameters selected for checking
in the IP checking mode; used to add or subtract
parameters in the IP setting mode.
9.
"VOL+" Button
 Used to turn up the volume in the play mode;
used to switch parameters selected for checking
in the IP checking mode; used to add or subtract
parameters in the IP setting mode.
10.
Button
 Used to select the next song program in the play
mode; used to move right one screen/right one
bit, and select parameters for checking/setting in
the IP setting mode.
11.
Button
 Used to select the previous song program in the
play mode; used to move left one screen/left one
bit, and select parameters for checking/setting in
the IP setting mode.
12.
Button
 Play/Pause button. It is used to play / pause the
program when playing local MP3 programs; used
to save the setting result when setting the IP.
The specifications will be subject to change without prior notice.
Copyright © Guangzhou DSPPA Audio Co.,Ltd All rights reserved.
12
11
10
9
VOL+
USB
F1
Set
VOL-
5
6
7
8
12
11
10
9
VOL+
USB
F1
Set
VOL-
5
6
7
8