DSPPA PAVA9500 Manual - Página 6

Navegue en línea o descargue pdf Manual para Amplificador DSPPA PAVA9500. DSPPA PAVA9500 10 páginas. 8-zone amplifier host with main/backupswitching

Imprimir página

Press and hold the button to play the recorded audio repeatedly.

9—Microphone Pickup Window

10—Recording Indicator

When you press and hold the REC button, this indicator light lights up normally red; when you release the REC button,

this indicator light goes out.

11—Handheld Emergency Paging Microphone Holder

When the microphone is not in use, put the hook on the back of the microphone into this holder.

12—Emergency Microphone Output Sensitivity Control

13—Multi-function Reset Button

 Respond to the system status.

a. If the device is working normally or if the button is pressed once after an abnormality is diagnosed in the system

and pressed again when the "SYS STATE" indicator light is normally on, the device will have no other response.

b. If an abnormality is diagnosed in the device, the "SYS STATE" indicator light will flash intermittently. After pressing

this button, the "SYS STATE" indicator light will be normally on and no longer flash, indicating the device fault

status, and the buzzer will stop unless a new abnormality is diagnosed in the system.

c. When the system is executing a timing point, press this button to disable the current timing point.

14—Circular Connector

Note: It is mainly used to connect and fix the emergency microphone.

15—EVAC Voice Message Button and Status Indicator

 When the EMERGENCY indicator light is flashing, press this button and then the indicator light will light up. If the

ALERT MSG indicator light is on, press this button and then the ALERT broadcast will be stopped, the ALERT MSG

indicator light will go out, and the EVAC alarm voice will be broadcast.

 When the EMERGENCY indicator light goes out, press this button and it does not work.

 Green - The current "EVAC MSG" voice message is being broadcast.

 Off - The current "EVAC MSG" voice message is not broadcast.

 Yellow - The current "EVAC MSG" voice message is lost or the SD card is faulty.

16—ALERT Voice Message Button and Status Indicator

 When the EMERGENCY indicator light is flashing, press this button and then the indicator light will light up. If the

EVAC MSG indicator light is on, press this button and then the EVAC broadcast will be stopped, the EVAC MSG

indicator light will go out, and the ALERT alarm voice will be broadcast.

 When the EMERGENCY indicator light is off, press this button and it does not work.

 Green - The current "ALERT MSG" voice message is being broadcast.

 Off - The current "ALERT MSG" voice message is not broadcast.

 Yellow - The current "ALERT MSG" voice message is lost or the SD card is faulty.

17/19—Audio Treble/Bass Control

18—Monitor Volume Control

20—Remote Paging Microphone Volume Control

21—Master Zone Output Volume Control

22—ALL ON/OFF and Status Indicator

 Green - Forcibly turn on all zones in the system (please note that it refers to the entire system, not limited to the

local device).

 Off - Restore the state of zones in the system before the forced-open operation.

a. When all zone output indicator lights of the machine are currently off, press this button to turn on the output of all

zones of the machine.

b. When all zone output indicator lights of the machine are currently on, press this button to turn off the output of all

zones of the machine.

c. When the Long Press ALL SET indicator light of the machine is currently off, long press this button for 1 second to

turn on the output of all zones of the whole system.

d. When the Long Press ALL SET indicator light of the machine is currently on, short press or long press this button for 1

[email protected]

www.dsppatech.com

The specifications will be subject to change without prior notice.