Attainment Company Voice Cue Instrucciones

Navegue en línea o descargue pdf Instrucciones para Grabadora de voz Attainment Company Voice Cue. Attainment Company Voice Cue 2 páginas. Auditory cueing – verbal prompting 5 messages

Imprimir página

Attainment's

Voice Cue

Auditory Cueing – Verbal Prompting

5 messages

instructions

set current time

The clock setting buttons (T1 and T2)

are pen push — use the tip of a ballpoint

pen to press the recessed button.

HOUR:

1. Press T1 button once (located right

of the LCD clock) to cause the hour

indicator to blink.

2. Press and release (or hold down) T2

button to advance to the desired hour.

MINUTE:

1. Press T1 again for the minute indicator

to blink.

2. Press and release (or hold down) T2 to

advance the minute indicator to the

desired time.

DAY:

1. Press T1 again to cause the day

indicator to blink.

2. Press and release (or hold down) T2 to

advance to the desired day.

12 or 24 HOUR:

1. Press T1 again to cause the 12 hour

indicator to blink.

2. Press T2 to toggle to desired 12 or 24

hour clock settings.

3. Press T1 again to end time setting/

editing procedure.

record messages

1. Press and release RECORD button.

This causes the blue LED to turn on.

a. The blue LED will turn off if a

message button is not pushed

within 5 seconds.

2. Press and hold any of the 5 message

buttons (located above the speaker).

The five message buttons are pen

push — use the tip of a ballpoint pen

to press the recessed button.

a. While recording, the LCD will

display a countdown of remaining

recording seconds. Each of the five

messages holds up to 12 seconds.

b. During the recording of messages

the blue LED will turn off.

3. Begin recording desired message.

4. Release message button when

recording is complete.

playback

Press and hold the message button

for the length of the message.

replay button

Replay button will replay the

last message within 25 seconds after

the message plays.

set automatic playback

1. Press and release TIME button. This

causes two fields to blink. Both are

located on the left side of the LCD.