Attero Tech BoomBox NA4 Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Amplificador Attero Tech BoomBox NA4. Attero Tech BoomBox NA4 15 páginas. 4 channel combranet amplifier

Imprimir página

3 – Configuration

Configuration of the BoomBox requires the use of the Attero Tech Control Center application. Refer to the Attero Tech

Control Center User's Guide for installation and setup instructions for the application.

*Note: Setup of CobraNet parameters on the BoomBox such as bundle setup is done the same as any other device and

can be done with software other than Control Center. However, other configuration settings use parameters that are

outside the standard set of CobraNet parameters and they require Control Center to set them.

3.1 – Audio Configuration

The BoomBox can only make use of two streams at any one time. These audio streams can be selected from any

submap of any bundle the BoomBox can receive. Use the Bundle Setup form in Control Center for the BoomBox to

setup the required incoming CobraNet audio.

Figure 3 - Bundle Receiver setup

*Note: To ensure the bundle setup is retained during power down, ensure that the BoomBox also has persistence

enabled (on the main form).

3.2 – Output Controls

Configuration of the BoomBox output parameters can be

done by selecting the device in the device list on Control

Center and then clicking the Device Setup button.

Alternately, you can right click on the desired device and

click on the Device Setup option from the menu that pops

up.

As can be seen from Figure 4, the BoomBox has a set of

local output channel controls as well as a master set of

controls. The output level of a given output is a

combination of the settings for the local channel controls

for that channel and the master controls.

3.2.1 – Master Controls

Each BoomBox has a master volume control and a master

mute control (see the left most controls in Figure 4). The

master volume does not override the individual channel

volumes but works with them, reducing or increasing, the

volume on all channels simultaneously.

The master mute will, when active, mute all output

channels. Any changes to any local channel controls or the

master volume control will not have any affect on the

output level whilst the master mute is active.

Typing "33" into one of the receiver submap fields

designates that particular audio stream to be

channel 1. Alternately, type "34" to designate a

particular audio stream to be channel 2. You do

not have to use both if both streams are aren't

required though if you don't designate a stream

for an output and later try and use it, the

BoomBox will output nothing.

*Note: Both 33 and 34 can only exist once in a

particular receiver submap table. If more than

one field has 33 or 34 and both bundles are

active, the output audio may not be what is

expected!

Figure 3 shows a receiver setup where both audio

streams are being taken received from a single

bundle.

Figure 4 - BoomBox Configuration Screen

Page 5

BoomBox NA4

User Manual

614-00006-02