3onedata ICS5400 Series Manual de instalación rápida - Página 2

Navegue en línea o descargue pdf Manual de instalación rápida para Interruptor 3onedata ICS5400 Series. 3onedata ICS5400 Series 4 páginas. Rack-mounted layer 3 industrial ethernet switch

Imprimir página

Device indicators, from left to right in turn they are:

Ethernet port indicator (G1-G24/28/32/40,

X1-X4)

Power indicator (P2-P1)

Alarm indicator (ALM)

Running indicator (RUN)

DC power supply input terminal blocks

10.

AC power 2 supply input socket (PWR2)

11.

AC power 1 input socket (PWR1)

【Mounting Dimension】

The external dimensions of this series of products are the

same, unit: mm.

DC device



AC device



Notice Before Mounting:

Don't place or install the device in area near water or



moist, keep the relative humidity of the device

surrounding between 5%~95% without condensation.

Before power on, first confirm the supported power



supply specification to avoid over-voltage damaging the

device.

The device surface temperature is high after running;



please don't directly contact to avoid scalding.

【Rack-mounted】

This product adopts 1U rack-mounting, mounting steps as

below:

Step 1

Select the device mounting location to ensure

enough size.

Step 2

Adopt 4 bolts to install the mounting lugs in the

device position as figure below.

Step 3

Place the device in the rack; adopt 4 bolts to fix two

sides mounting lugs in the rack.

Step 4

Check and confirm the product is mounted firmly on

the rack, mounting ends.

【Disassembling Device】

Step 1

Power off the device.

Step 2

Adopt screw driver to loosen the 4 bolts fixed on

the mounting lugs in the rack.

Step 3

Shift out the device from rack, disassembling ends.

Notice before power on:

Power ON operation: First insert the power supply



terminal block into the device power supply interface,

then plug the power supply plug contact and power on.

Power switch "—" means power ON, "O" means power



OFF.

Power OFF operation: First, put the powers switch to



the "O" side and then disconnect the power supply.

Finally disconnect the connector between the device and

the power cord. Please notice the operation order above.

Please be aware of the power input range supported by



the device before powering on. Use the recommended

voltage of the device to avoid device damage.

【Power Supply Connection】

DC device power supply



Model I- Model IV provide 5-pin

5.08mm pitch terminal blocks and the

built-in dual power supply redundancy

supports DC power input. The power

input supports 1 single power supply

input or 2 power supply inputs at the same time; When two

power supply input at the same time, it supports redundant

backup of power supply. If one power supply fails, the device

can still work normally without interruption. Power supply

supports anti-reverse connection, which cannot power the

device but won't damage it when it's reversely connected. The

definitions of power pin are shown in the left figure, and the

power input range is 24VDC/48VDC (12~55VDC).

AC device power supply

