DStv Drifta Manual rápido - Página 3

Navegue en línea o descargue pdf Manual rápido para Media Converter DStv Drifta. DStv Drifta 5 páginas. Mobile decoder
También para DStv Drifta: Manual rápido (5 páginas)

Imprimir página
DStv Drifta Manual rápido
• Green steady light - Drifta is ready to transmit data to a pairing device over Wi-Fi.
• Green slow flickering light - Drifta is transmitting data to a paired device over the Wi-Fi network
When all lights are o , it means the Drifta is o .
5. Power Button turns the Drifta on or o . Press and hold to power on. Press and hold for three seconds
to power o .
6. Reset Button
(pin hole)
7. Mini USB is used with the provided USB Cable to connect the device to a PC USB port to recharge or to
watch the DVB-H broadcast using the PC application.
8. CAS Number is used when activating the Drifta.
9. Device ID is used when pairing with a viewing device over Wi-Fi.
back of the device.)

Before using the Device

Charge the battery
The Drifta contains a removable rechargeable battery. When using it for the rst time, charge the battery.
A full charge will take 60 minutes.
To charge the device, connect it via the USB cable to a USB port of a PC, or a USB power adaptor.
Take note of the power and battery light during charging.
A fully charged battery gives about 3 hours of viewing.
Using your Drifta
Step 1: Your Drifta needs to be activated before using the service. Please contact MultiChoice Customer
Care to activate your device.
Johannesburg: (011) 289-2222
Pretoria: (012) 422-2222
Durban: (031) 710-2222
Cape Town: (021) 508-2222
Port Elizabeth: (041) 395-2222
Bloemfontein: (051) 503-2222
Step 2: Install the Drifta client software on your viewing device by following the instructions in this quick
guide.
Connecting to a PC
Minimum System Requirements
Operating System: Windows® XP, Vista or 7
Processor: 32 Bit or 64 Bit
Minimum Memory: 512MB
Minimum Disk Space: 100 MB
USB Port

Installing the Application

1. Insert the Drifta Application CD and run the Windows setup application. Complete the installation.
2. Connect the Drifta to the PC with a USB Cable.
3. Press the power button on the Drifta. Wait for the DVB-H light to go steady green.
is used to reset the Drifta to factory settings.
(See resetting instructions further on).
(This can be found on the Drifta box or on the