DSYS DL4B Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Luz de trabajo DSYS DL4B. DSYS DL4B 8 páginas. Mini rc led lighting

Imprimir página

LED Powering from Driver Battery (4 - 24V). Connect LED anodes to

positive (+) battery pole. The maximum number of connected LEDs is

determined by the battery voltage per formula: Uaku -0,6-(n x Uled).

Uaku= battery voltage, 0,6V=stabilization, n=number of LEDs,

Uled=LED voltage. The calculated value must be between 0 - 5

(otherwise its overloaded).

Example 1.

RAMP 4 LED. Power 2S Li-Pol (2 x 3,7 = 7,4V).

E1, 2

Connect in parallel two 2x 3.2V LEDs in series.

anodes to positive (+) battery pole.

to L4). Do not connect LED E5 and resistor R1.

Example .

2 RAMP 5 LED. Connect LED E5 with R1 resistor to RAMP 4.

Calculation

for RAMP 4 and 5 LED: 7,4 - 0,6 - (2 x 3,2) = 0,4 (OK)

Insert jumper F1 through F6 into connector K3 to set the DL4B function.

Connect the control cable to the switched on receiver. When the

power is connected, LED L2 indicates the selected function by the

number of flashes (The K3 status is read only when it is switched on).

Signal loss: LEDs L2 to L4 are off.

Control: Stick / Wheel / Switch Position 2P / 3P Switch.

Range throttle.

1,5ms.

Fwd

Unidirectional

„-"

no function, no light.

Functions with F1 jumper:

Stick

Bwd

lights constantly

lights

E3, 4

R1 220R

OPERATION

Reversible

(car, boat, TIR).

>1,5ms.

(Airplane,

dinghy

OPTIONAL SETTINGS

Neutral

Fwd

lights

Connect the LEDs E3, 4 to pin L (L1

Bwd

). Stop: =<1,2ms.

Functions with F2 jumper:

Stick

Bwd

blinking

GND

Connect LED

: <1,5ms. Neutral:

Fwd

>1,2ms.

Neutral

lights constantly

lights

blinking blinking

E1, E2

Fwd

lights