ATTO Technology Celerity CTFC-161P Manual de introducción

Navegue en línea o descargue pdf Manual de introducción para Adaptador de host ATTO Technology Celerity CTFC-161P. ATTO Technology Celerity CTFC-161P 2 páginas. Fibre channel host adapter

ATTO Technology Celerity CTFC-161P Manual de introducción
2.
Remove the cover bracket from a PCIe slot. PCIe slots and adapters vary in the number of
connectors present, depending on the data lanes being supported.
3.
Insert the adapter in an available, compatible PCIe slot. Push the adapter into the slot until
the adapter is firmly seated. The adapter can be installed in a x8 or x16 mechanical PCIe slot.
4.
Connect Fibre Channel devices by inserting a Fibre Channel cable from the devices to the
connectors on the Celerity FC host adapter until you hear a click.
Some PCIe adapters may have a short connector. Excessive force could break the
connector. Use caution when pressing the board into the slot.
5.
Repeat steps 2 through 3 for each adapter you want to install.
6.
Replace the server cover and plug in the power cord.
7.
Turn the power on.
Configure your Adapter
Default settings are appropriate for most systems, but you may change the default settings using
the Device Manager in Windows or the ethtool in Linux.
ATTO Technology, Inc.
155 CrossPoint Parkway
Amherst, New York 14068 USA
www.atto.com
Tel (716) 691-1999
Fax (716) 691-9353
Sales support: [email protected]
Technical support: [email protected] (716) 691-1999 x242
© 2020 ATTO Technology, Inc. All rights reserved. All brand or product names are trademarks of
their respective holders. No part of this document may be reproduced in any form or by any means
without the express written permission of ATTO Technology, Inc.
8/2020
Thank you for purchasing the ATTO Celerity FC Host Adapter. This guide gives you the basics for
installing and configuring your adapter. For more information, please visit our website at
www.atto.com
Overview
This guide covers hardware and software installation, setup procedures, and troubleshooting tips
for ATTO Celerity Fibre Channel adapters. Ensure you have the equipment and software you need
for the installation:
System Requirements
Before installing the ATTO Celerity Fibre Channel adapter, please check your system for the
following minimum configuration requirements:
Supported Operating Systems
supported operating systems.
Installing Drivers
Configure your system to recognize and use your Celerity HBA by installing drivers for your
operating system.
PRMA-0400-000MD
Celerity™ Fibre Channel Host Adapter Getting Started Guide
Celerity Fibre Channel adapter
A computer with an available PCIe, PCIe 3.0, or PCIe 4.0 expansion slot
Storage, cables, and connectors
ATTO ConfigTool™ Configuration and Management Utility
Microsoft Windows®
Microsoft Windows Server®
macOS®
Linux®
VMware®
FreeBSD
illumos
Please visit
https://www.atto.com/support/interoperability/
for details on specific