DTD STREAM RING 23 Manual del usuario - Página 12
Navegue en línea o descargue pdf Manual del usuario para Instrumento de buceo DTD STREAM RING 23. DTD STREAM RING 23 18 páginas. Buoyancy compensator
También para DTD STREAM RING 23: Manual (6 páginas)
Imprimir páginaTUNING THE COMPENSATOR
1.
Assembly of the compensator for using with single bottle
We recommend first bolting the wing and the backplate loosely together. Run
the bolt through the wing and then the backplate in such a way that the nut
faces your back and the bolt head shows up on the wing. Do not tighten the bolt
yet; the wing should be loose enough on the backplate to facilitate the
assembly. Attach the wing in such a way that the logo can be seen while looking
at the backplate; that is, the corrugated hose knee-joint is on the opposite side
from the backplate.
Attaching the inflator: detailed description in „2. Assembly of the compensator
for use with doubles".
How to thread the bottle straps
Pass the straps with the buckle designed to hold the cylinder through a strap
slot in the wing (1). The Velcro on the strap must be turned to the outside, in
the direction of the wing's perimeter. Continue by threading the strap through a
corresponding horizontal slot in the backplate (2), and then through a slot on
the other side of the backplate´s bending (3). Then thread the strap through a
strap slot in the wing (4, 5). Move the strap so that the Velcro near the buckle
runs through both strap slots of the wing. Leave about 10 cm of the strap close
to the buckle without threading it through the wing. Follow the same procedure
for the second strap.
pic. 1
pic. 4
Revised – February 2020
pic. 2
pic. 5
pic. 3
pic. 6
11