Attwood 91022 Instrucciones de instalación - Página 2

Navegue en línea o descargue pdf Instrucciones de instalación para Iluminación marina Attwood 91022. Attwood 91022 2 páginas. Attwood plastic stowaway light base installation instructions

Attwood 91022 Instrucciones de instalación
FINAL WIRING FOR:
91020, 91022 (2 wire base): Connect one black wire to the battery
ground (-) harness, using a crimp-on wire connector. Attach the
remaining black wire to the positive switched wire from the navigation
light switch.
91021 (3 wire base): Connect black wire to the battery ground (-)
harness, using a wire connector. Connect the blue wire to the wire
from the switch for the courtesy light. Use a wire connector to make
the connection. Connect the gray wire to the wire from the switch for
the navigation running lights using a wire connector.
All positive wires must be fused according to light specs to protect
the circuit. MAKE SURE POWER SOURCE IS 12-VOLT D.C. ONLY.
HIGHER VOLTAGE CAN CAUSE DAMAGE TO LIGHT AND WIRE
CIRCUITRY.
Insert light pole into base and press down to make contact. Insert
lock collar into base opening, rotate if necessary to push it down into
base. Rotate collar until tight to hold light pole in base. Test light
operation. Remove and stow light. Close cover to protect contacts
when not in use.
Part #91020, 91021
Part #91022
This product carries the standard Attwood one-year limited
warranty. See product catalog for details.
© 2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com