DTM System NANO II 150 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Receptor DTM System NANO II 150. DTM System NANO II 150 8 páginas. 1-channel
También para DTM System NANO II 150: Manual del usuario (16 páginas)

Imprimir página

GENERAL INFORMATION

The series of 1-channel radio receivers NANO2 is designed to work with gate controllers, roller shutters and other automation

devices where a control pulse is required. It allows, in a simple and cost-eﬀective way, to extend the installation functionality

with a remote control.

TECHNICAL DATA

memory

frequency

power supply

power consumption

output

output load

operation mode

temperature

ingress protection

dimensions

with mouting brackets

1.Installation

Receiver is designed for use inside buildings or inside

other automation devices. Ensure proper operation

condidtions in line with technical parameters. Do not

mount in locations exposed to high humidity and

frequent sudden temperature changes.

Due to the externally accesible screw connection

provide galvanic isolation from other devices and

wires. Attention should be paid to thermal insulation

of automation elements which can reach high

temperatures (motors, transformers, circuits

implementing, heat sink etc.). For electrical

connection see Fig. 1.

Factory wire antenna is connected to antenna

terminal. Optionally external antenna can be used.

Connect external antenna with 50Ω impedance

coaxial cable to Y - center core,

2. Receiver programming

2.1. Adding the remote control into the receiver's

memory

In order to add the remote control into the receiver's

memory, press the receiver button and press the

selected remote control button. The LED blinks

indicating the add, release the receiver button. The

selected button of the remote control will control the

output channel of the receiver. Any button of the

remote control can be added in the receiver's

memory.

Holding down the receiver button for more than 15 seconds will remove all the remote controls from the receiver.

Attempting to add another remote control into the already-ﬁlled memory of the receiver will fail..

15 remotes

DTM433MHz

+other producers

Approx. 30mA (with relay ON)

monostable, turn-on time 1s

- shield.

Fig. 1. View of the receiver

with pin description.

Fig. 2. Adding a remote control.

150 remotes

DTM433MHz

one, separated NO type

-20°C / +55°C

PRESS C1 BUTTON

PRESS REMOTE CONTROL

LED PULSES

BUTTON

150 remotes

DTM433MHz

+other producers

programming

button with LED

pin description

12-24V

power

antenna

C1 BLINKS x3

- ADDING SUCCESSFUL,

RELEASE C1 BUTTON