3onedata IES6220 Series Manual de instalación rápida - Página 2
Navegue en línea o descargue pdf Manual de instalación rápida para Interruptor 3onedata IES6220 Series. 3onedata IES6220 Series 4 páginas. Managed industrial ethernet switch
Imprimir página
Model I
Model III, IV, V
1.
Wall-mounting location hole
2.
DIN-Rail mounting kit
3.
DC power input terminal block
4.
Relay alarm output terminal block
5.
Console port
6.
DIP switch
7.
Grounding screw
8.
Device running indicator RUN
9.
Relay alarm indicator ALM
10.
Power input status indicator P1/P2
11.
100M copper port connection indicator
12.
100M copper port
13.
Gigabit SFP slot
14.
Gigabit SFP connection indicator
15.
100M PoE port
16.
PoE indicator
【Mounting Dimension】
Unit: mm
Attention before mounting:
Model VI, VII, VIII
【DIN-Rail Mounting】
The product adopts 35mm standard DIN-Rail mounting,
which is suitable for most of the industrial scenes.
Mounting steps as below:
Step 1
Step 2
Step 3
【Disassembling DIN-Rail】
Step 1
Step 2
Don't place or install the device in area near water
or moist, keep the relative humidity of the device
surrounding between 5%~95% without
condensation.
Before power on, first confirm the supported power
supply specification to avoid over-voltage damaging
the device.
The device surface temperature is high after running;
please don't directly contact to avoid scalding.
Check if the DIN-Rail mounting kit is installed
firmly.
Insert the bottom of DIN-Rail mounting kit (one
side with spring support) into DIN-Rail, and then
insert the top into DIN-Rail.
Tips:
Insert a little to the bottom, lift upward and then
insert to the top.
Check and confirm the product is firmly installed
on DIN-Rail, then mounting ends.
Device power off.
After lift the device upward slightly, first shift out
the top of DIN-Rail mounting kit, then shift out
the bottom of DIN-Rail, disassembling ends.
Notes before power on:
Power ON operation: first connect power line to the
connection terminal of device power supply, then
power on.
Power OFF operation: first unpin the power plug,
then remove the power line, please note the
operation order above.
【Power Supply Connection】
DC power supply 24VDC
This series of model V, model VIII
provide 6 pins 5.08mm pitch input
terminal blocks, including 4 pins
power supply terminal blocks on the
left side. It provides two independent
DC power supply systems of P1 and
P2. The power supply is anti-reverse connection.
Power input voltage: 24VDC
DC power supply 48VDC
This series of model I, model III, model IV, model VI and
model VII provide 6 pins 5.08mm
pitch input terminal blocks, including
4 pins power supply terminal blocks
on the left side. It provides two
independent
systems of P1 and P2. The power supply is anti-reverse
connection.
Power input voltage of model III, model IV, model VI and
model VII: 48VDC, power input voltage of model I: 48VDC
(12~48VDC).
AC power supply 220VAC
This series of model II supports AC
single power supply and provide 6
pins 5.08mm pitch input terminal
blocks, including 4 pins power supply terminal blocks on
the left side.
DC
power
supply