Comtrend Corporation NexusLink 3120 Manual de instalación - Página 8
Navegue en línea o descargue pdf Manual de instalación para Pasarela Comtrend Corporation NexusLink 3120. Comtrend Corporation NexusLink 3120 12 páginas. High speed dsl
También para Comtrend Corporation NexusLink 3120: Manual de conexión (2 páginas)
Imprimir página
LED Status Lights
The front panel LED lights are shown below and explained in the following table.
This information can be used to check the status of the device and its connections.
LED
Colour
GREEN
POWER
RED
GREEN
ETH WAN
ORANGE
GREEN
ETH 4 to 1
ORANGE
WiFi 2.4G
GREEN
WiFi 5G
GREEN
DSL 1
GREEN
DSL 2
GREEN
GREEN
INTERNET
RED
8
Mode Function
On
The device is powered up.
Off
The device is powered down.
POST (Power On Self Test) failure or other malfunction. A malfunction
On
is any error of internal sequence or state that will prevent the device
from connecting to the DSLAM or passing customer data.
On
WAN is connected at 1000 Mbps.
Off
Ethernet WAN is not connected.
Blink
In TX/RX over 1000 Mbps.
On
Ethernet is connected at 10/100 Mbps.
Off
Ethernet WAN is not connected.
Blink
In TX/RX over 10/100 Mbps.
On
Ethernet is connected at 1000 Mbps.
Off
Ethernet is not connected.
Blink
In TX/RX over 1000 Mbps.
On
Ethernet is connected at 10/100 Mbps.
Off
Ethernet is not connected.
Blink
In TX/RX over 10/100 Mbps.
On
The wireless module is ready. (i.e. installed and enabled).
Off
The wireless module is not ready. (i.e. either not installed or disabled).
Blink
Data transmitting or receiving over WLAN.
On
The wireless module is ready. (i.e. installed and enabled).
Off
The wireless module is not ready. (i.e. either not installed or disabled).
Blink
Data transmitting or receiving over WLAN.
On
DSL link is established.
Off
The device is powered down.
Blink
The DSL link is training or some traffic is passing through DSL.
On
DSL link is established.
Off
The device is powered down.
Blink
The DSL link is training or some traffic is passing through DSL.
IP connected and no traffic detected. If an IP or PPPoE session is
On
dropped due to an idle timeout, the light will remain green if a DSL
connection is still present.
Modem power off, modem in bridged mode or DSL connection not
Off
present. In addition, if an IP or PPPoE session is dropped for any
reason, other than an idle timeout, the light is turned off.
Blink
IP connected and IP traffic is passing through the device (either direction).
Device attempted to become IP connected and failed (no DHCP
On
response, no PPPoE response, PPPoE authentication failed, no IP
address from IPCP, etc.)