ABSTRACT Twister4 HP Manual

Navegue en línea o descargue pdf Manual para Luz de inundación ABSTRACT Twister4 HP. ABSTRACT Twister4 HP 2 páginas.

Dip switch settings for 4 channel controllers

Maintenance

Keep the lens clean using a soft damp cloth.

Regularly remove dust and fluff from the fan cooling vents or the unit may

overheat.

To replace the lamp, first disconnect the mains power and wait for the unit to

cool if it has been running. Remove the panel under the lens. Remove the old

lamp by sliding it out of the metal clip. Pull the connector off the lamp pins. Plug

onto the new lamp and refit into clip. Replace cover.

Lamp type A1-259 (24V, 250W)

issue 1.1 © AbstractAVR Limited 2004

Tel 0116 278 8078 http://www.abstract.uk.com

Page 4

Twister4 HP

The Twister4 HP is the first in a range of Abstract "HP" products.

This sheet gives you a quick guide to how it works.

Setting the unit up

These controls and connectors are located on the end of the unit

opposite to the output lens.

1: (socket) DMX output or link through. Plug "slave" units in here.

2: (plug) DMX input, for a DMX desk or if this is a slave unit in a

stand alone system. Note: Pin 2 is "hot data"

3: Power On indicator (red)

4: DMX received, or Sound Beat indicator (green)

5: DMX address or Sound Option dip switches

6: Microphone

There is a rocker switch next to

the mains input on the rear of

the unit which dims the lamp

slightly to extend lamp life.

Connect 240V mains to the IEC

mains power input. When you

connect power the unit will go

through a short setup routine,

and will then begin to produce a

lightshow to sound, or if DMX is

connected, will respond to the

DMX input.

Focus the beam output by loosening the two screws on the top of

the case and sliding the lens back or forward.

Stand alone mode

The Twister4 HP has an advanced stand alone light show featuring

BPM sensing and product group controls. If no DMX is connected,

the unit will automatically work in stand alone mode. If you

connect other Abstract units to the DMX output, they will