Conair 17 PIECE HC117WCSC Instrucciones de uso y mantenimiento - Página 6
Navegue en línea o descargue pdf Instrucciones de uso y mantenimiento para Afeitadora eléctrica Conair 17 PIECE HC117WCSC. Conair 17 PIECE HC117WCSC 8 páginas.
Imprimir página
gers and cut to desired length. Always work-
ing from the front to the back of the head,
gradually cut the hair shorter by reducing
the space between the comb or fingers and
the head. Comb often to check for uneven
strands, and to get rid of trimmed hair.
OUTLINING:
Outlining requires no attachments. Comb
hair into the desired style. Position the
clipper between the sideburns and the ear
(see below), making sure the corner edge
of the blade is against the hairline. With
the outline of the hair as your guide,
slowly move the clipper over, around and
behind the ears. For the back of the neck
If you want hair to be
even shorter:
A ) A p p l y m o r e
pressure to the head
with the attachment
comb that is in place.
This takes a little
practice, of course.
OR
B) Just switch to a
shorter attachment
comb.
Remember, it's better
to leave too much hair
than too little. For
longer hair on top, use
the barber comb and
lift hair on the top of
the head, cutting over
the comb. Or hold the
hair between the fin-
and the sideburns, hold the clipper upside
down (see Fig. 1) and, holding it against
the skin at the length desired, move the
Fig. 1
clipper downward.
STOP. COMB. CHECK.
For best results, do as the professionals
do: comb hair often, and check clipping
results as you comb. This way you avoid
uneven sides, bangs, neckline, etc.
SHORT CUTS TO PERFECT
FLAT TOPS, CREW CUTS, ETC.
Always cut from the back of the neck to
the crown, using the longest comb setting.
Hold the comb attachment flat against the
head and slowly move the clipper up
through the hair. Use the same technique
for the sides, cutting from the bottom to
the upper side of the head.
For the front to the crown, cut
Fig. 2