DAN NTP TECHNOLOGY DAD THUNDER CORE AX64 Manual de instalación - Página 16

Navegue en línea o descargue pdf Manual de instalación para Equipos de grabación DAN NTP TECHNOLOGY DAD THUNDER CORE AX64. DAN NTP TECHNOLOGY DAD THUNDER CORE AX64 19 páginas. Thunderbolt 3, dante, madi and adat modular audio interface

Imprimir página

Reconfig button

The "Reconfig" button on the back of the AX64 should not be used during normal installation. It is generally

intended as an ultimate recovery function in case something goes wrong during programming of IP addresses or

a software upgrade, e.g. an unintended power loss. It allows the AX64 to start in various "basic" modes so it can

be restored without having to be returned to the factory.

The "Reconfig" button is accessed via a hole in the rear panel using a pen or a similar pointed item. A green LED

is visible through the hole. When the "Reconfig" button is activated, the LED will light up indicating the two

reconfig modes of the AX64.

Recovery mode

The selection of either of the two recovery modes are fixed after selection. The AX64 will start with a basic boot

software and IP configuration. The AX64 will not be operational until a proper firmware has been downloaded

via the DADman software and it has been restarted. By enabling recovery mode with default IP address and

network configuration the unit can always be identified on a network via the default setup.

Note that the IP address referred to is the IP address of the controller/management interface of the

unit. This is not the IP address of the IP audio interface if a such is installed. This IP address can not

be accessed in recovery or restore defaults mode.

Doc no. AX64-8001-A-4

"Reconfig

The AX64 enters a

pushed while the

only a basic boot software is operative in the unit,

unit is powering

and new software can be downloaded via the

DADman software. This mode is used if the

software in the AX64 for some reason is not

Green LED

operative or broken.

turns ON

The IP address settings of the unit are the last

setting used in the unit.

The AX64 remains in reconfig mode as described

"Reconfig

above.

short push

while the unit is in

The IP address settings of the unit is however set to

reconfig mode and

DHCP. In case there is no DHCP server on the

Green LED is on

network, the AX64 will default to IP address

10.0.7.20 / 255.255.0.0 after approx. 2 minutes.

Green LED

turns OFF

Rev. date 221023

recovery

mode. In this mode

Page 16 of 19