DAN DRYER BJORK 3010 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Secadora DAN DRYER BJORK 3010. DAN DRYER BJORK 3010 10 páginas.
También para DAN DRYER BJORK 3010: Instrucciones de montaje (2 páginas)

Imprimir página

INSTALLATION

• Make sure the main breaker is turned off. Installation must be carried out by a

qualified person in accordance with standards applicable in the country where

the equipment is to be installed.

• Place template against the wall at desired height (see mounting height recommendation)

and mark location of (4) mounting holes and the wire service entry.

1. Remove the two screws in the lower area of

the unit and remove the casing from its base.

3. Attach the hand dryer base plate to the wall

with the screws supplied with the unit.

5. Connect supply wires to terminal block:

4. Insert the power cord through the inlet hole.

Fasten with the retaining clip.

CONNECTIONS:

A ( 1 : 1 )

Connect live wire (coloured red or brown) to the

terminal block marked "L"

Connect neutral wire (coloured blue) to terminal blcok

marked "N"

Connect the ground wire (coloured green and yellow)

to the terminal block marked " "

NOTE

Colours of live and neutral wires depend on

voltage of supply service.

2. Place the mounting

template on the wall at the

desired location. Drill (4) holes

as indicated.