concept 2 DYNO Manual de instrucciones de montaje - Página 8

Navegue en línea o descargue pdf Manual de instrucciones de montaje para Gimnasios concept 2 DYNO. concept 2 DYNO 12 páginas.

14a. Remove the wooden block

holding the round Plastic Clamp

Pad in place on the Handlebar

Assembly. Note the position of

the two flat plastic clamp liners.

If these are loose, be sure to

keep them in position as you

proceed. Loosen the knob and

remove the wooden piece.

14b. Slide the Handlebar Assembly on the mast as shown, assuring that

the Plastic Clamp Pad is in place. Tighten the Handlebar Knob lightly.

Handlebar

Assembled Cable Style D-Handle

15. Install the D-Handles to the handlebar by removing the bolt and

washer from the D-Handle assembly and attaching the assembly

to the Handlebar as shown. Repeat this for both handles. Tighten

firmly with a 1/2" wrench.

13a. Roll the Carriage Assembly on the Monorail so

that its holes line up with the holes in the Chain

Connector Plate. You will need to press the

plate up into the slot to get it between the

bottom rollers of the Carriage.

13b. Attach the Carriage to the Chain Connector

Plate as shown using the four Connector Plate

Spacers and two 3/8" by 3 1/2"bolts and two

3/8" nuts. It may be necessary to lightly tap the

spacers into place or to loosen the fasteners

holding the two bottom rollers. Tighten firmly.

Connector Plate Spacers

11/01