Elite Acoustics Engineering A4-58 Manual de inicio rápido - Página 11
Navegue en línea o descargue pdf Manual de inicio rápido para Amplificador Elite Acoustics Engineering A4-58. Elite Acoustics Engineering A4-58 13 páginas. 120w lithium battery powered acoustic amplfier with 4 channels, mixer, effects, and bluetooth
Imprimir página
R1 - Bright Cavern
R2 - Dark Cavern
R3 - Bright Hall
R4 - Dark Hall
R5 - Bright Room
R6 - Dark Room
R7 - Bright Plate
R8 - Dark Plate
•
•
There are 16 total Digital EFX programs
•
R1 to R10 - REVERB
•
E1 and E2 - ECHO
•
ER1 and ER2 - Echo and Reverb
•
CHO - Chorus
•
FLange - Flanger
•
•
Program select Encoder (10) is for program change.
•
Parameter knob (9) to change rate or delay time for the program that is set.
•
Mix knob (8) is to fine turn the amount of EFX you want in output mix.
•
EFX can be bypassed by Pressing the bypass switch (9)
•
EFX send levels for each channel is set by on the rear panel ( 14, 24, and 31) that
correspond to each channel.
•
•
Distorted Sound
•
1) Check input level to make sure input Signal Light is in GREEN and not CLIPPING
RED. Reduce Input by turn down GAIN knob (12, 22, 30), input Gain can also be re-
duced by Pressing "PAD" (16, 26), some MIC or PRE-AMPs have very high output level,
using the PAD switch for those devices and will help you reduce the chance of distortion.
Make sure all EQ knobs are set to Middle. (FLAT)
•
2) Check Monitor Signal Light is also GREEN and not Clipping. Reduce Speaker Level by
turning Monitor Knob (3), make sure EQ is set to middle (FLAT)
•
•
No Sound
•
1) Check LED signal lights. Green means there is Signal on the input.
•
2) Make sure MIX knob is at 12 o' c lock position.
•
3) Make sure Channel is un-muted.
•
4) Make sure +48V is on when using a Condenser Mic. Make sure to MUTE when turning
on +48V to prevent loud POP sound.
•
•
Battery not Holding Charging
•
1) Power unit off and charge the unit for 24 hours with Battery switch in Connected
position. If problem still persist, contact [email protected] for battery replacement
instructions.
DIGITAL EFX
16 DIGITAL EFX PROGRAMS
TIPS
R9 - Ambience1
R10 - Ambience2
E1 - Echo
E2 - Repeat Echo
ER1 - Echo/Rev1
ER2 - Echo/Rev2
CHO - Chorus
Flange - Flange