Ducati SW400 FC Manual - Página 2

Navegue en línea o descargue pdf Manual para Abrepuertas Ducati SW400 FC. Ducati SW400 FC 11 páginas.

1. Manual Release

DUCATI

General installation diagram: mechanical limits & pillar dimension

PULL TO OPEN OPERATION (gate that opens towards inside)

This means the gate operator is mounted on the inside of the property and pulls your gate in towards the property to open.

Warning: Each actuator model has limits to the use of measurements A and B. Therefore, verify the conformance of the actuator model with the size of your structure (see

following pages the measurement limits A and B for each actuator model). The greater the distance between the gate hinge and the inner edge of the pillar, the longer the

chosen actuator will be. It is recommended to install actuators with a certain incidence

mance.

A and B measure the distance between the gate hinge and the rotation center of the actuator (respectively on longitudinal axis and transversal axis). These measurements

determine the maximum opening gate and opening speed of the gate. Check the A & B limits for each actuator model in the following pages.

CAUTION: It is recommanded not to use the entire stroke of the drive and to install actuators with a certain incidence angle over the gate.

CAUTION.:The gate opening speed depends on the length of the actuator's run used. The less run (stroke) you use, the faster the gate will open.

PUSH TO OPEN OPERATION (opens towards outside)

The gate opener is mounted on the inside of the property and pushes your gate out away from the property. PUSH-TO-OPEN.

Check the overall dimensions before installation.

It is recommanded not to use the entire stroke of the drive and to install actuators with a certain incidence angle over the gate

Warning: use of telescopic actuators is recommended.

Warning: remember to reverse the polarity of the motor cables when connecting to the electronic board

In line with center hinge

Rear pivot point of gate opener

ngle over the gate (not too parallel to the gate itself) for better mechanical perfor-

Pillar dimension:

How this influences your gate opener system. Determinate the ideal A & B measure

A= distance between the hinges of the gate and the actuator's post fixing pin. This distance can be chosen by the user.

It is recommended to use a measure similar to the "B" measure.

B= is te most relevant measure and determinates gate opening speed and max. opening angle. it's determinated by the pillar

dimension + fixing bracket.

Shorter B measure determinates faster opening of your gate.

If you require major opening angle choose a short B measure and longer A measure

V= gate hinges

K = post fixing bracket

H = front fixing bracket

Longer telescopic actuators, allow better mechanical operation given by the greater strength of the lever.

Carefully evaluate the size of the pillars in relation to the tables that you will find in the pages that present the limits of use and

A= this measure must allow the actuator can open the gate wing at 90 °.

outside

B= This measure allows the actuator mounting. Compare it to the actuator dimension

Longer telescopic actuators, allow better mechanical operation. Make sure that the gate do not open onto

a public passageway. It is advisable to prepare a plant with safety photocells to be placed in such a way

inside

that the doors, opening towards the outside do not create damages to things and people who are on the

outside of the property, such as parked vehicles.