Anybus Wireless Bridge II Manual de instalación - Página 13

Navegue en línea o descargue pdf Manual de instalación para Adaptador Anybus Wireless Bridge II. Anybus Wireless Bridge II 17 páginas.

Configuration

4.5

Configuration Examples

Settings not mentioned here should be left at their default values.

Ethernet Bridge over WLAN – Easy Config setup

This example describes how to connect two Ethernet networks over WLAN using

two Wireless Bridges. Both units are configured using only the MODE button.

Power on the first Wireless Bridge, wait for the LEDs to light

up and go out, then press MODE and release it immediately.

Press MODE repeatedly until only LED C is lit, indicating

Easy Config Mode 4, then confirm by pressing and holding

MODE for 2 seconds.

This unit will now be discoverable and open for automatic

configuration.

Power on the second Wireless Bridge, wait for the LEDs to

light up and go out, then press and release MODE.

Press MODE repeatedly on the second unit until A + C are lit,

indicating Easy Config Mode 5, then confirm by pressing and

holding MODE for 2 seconds.

This unit should now automatically discover and configure

the other unit as a WLAN client.

PROFINET communication

WLAN communication with PROFINET devices requires that Bridge Mode is set

to Layer 2 tunnel on the WLAN Settings page of the web interface.

Anybus

Wireless Bridge II

™

Installation Guide

13 (16)

SCM-1202-013/SP2167 1.1