ADDER ADDERLink INFINITY 4000 Inicio rápido

Navegue en línea o descargue pdf Inicio rápido para Enrutador de red ADDER ADDERLink INFINITY 4000. ADDER ADDERLink INFINITY 4000 2 páginas.

Imprimir página

ADDERLink™ INFINITY 4000 configuration via web pages

Each ALIF4000 unit hosts its own internal set of web pages which contain all configuration details

and settings. You will need to use a computer connected to the same network as each ALIF4000

unit to access the web pages. Additionally, on the console attached to the ALIF4000 RX unit, you

can access its configuration details via the On Screen Display (OSD) by pressing CTRL + ALT + C.

To configure ALIF4000 units via their web pages

Run a web browser on your computer and enter the IP address of the required ALIF4000 unit:

TX: 169.254.1.33

The default addresses are

If the IP address of a unit has been changed, you can either:

• Discover the unit's main IP address by pressing the small

button on the front panel next to the OLED screen to reveal

the value for IP Address 3.

• Alternatively, providing it is appropriate to do so, perform a manual factory reset (see the

center pages) to restore the default address.

The opening page should be displayed:

www.adder.com/en/kvm-solutions/adderlink-infinity-4000

www.adder.com

Part No. MAN-QS-ALIF4000-ADDER_V1.0

RX: 169.254.1.32

and

IP Address 3

169.254.1.33

Full user details and setup instructions can be found at:

ADDERLink

Welcome

This quick start guide covers some of the key points of the ADDERLink™ INFINITY 4000 unit. Full user details

and setup instructions can be found at www.adder.com/en/kvm-solutions/adderlink-infinity-4000

Please read the supplied safety instruction leaflet before use.

Initial configuration

ALIF4000 units can be linked in two mains ways: Direct or Networked.

Direct linking

Where ALIF4000 transmitters and receivers are directly linked to each other, very little configuration

action is required, provided that they both have their factory default settings in place - just link them

together. If the standard settings have been changed in a previous installation, you merely need to

perform a manual factory reset on each unit. Please see the center pages.

ALIF4000 TX

Networked linking

Where ALIF4000 units are connected via networked links, you can either configure them individually,

or configure them collectively using an AIM server:

• Configuring networked ALIF units individually - You need to specify the network addresses

of the ALIF4000 units so that they can locate each other. This can be done using via OSD on the

console connected to the RX unit by pressing CTRL + ALT + C. Please see the rear page.

• Configuring networked ALIF units collectively - The ADDERLink™ INFINITY Management

(AIM) server allows you to configure, control and coordinate any number of ALIF transmitters and

receivers from a single application. See adder.com for details.

Note: If you are using one or more ALIF4000 transmitters

within an installation managed by an AIM server, the AIM

server must be running firmware version 4.9 or above.

10 Gigabit

ALIF4000 TX

Switching

IMPORTANT: When using AIM to configure ALIF units, it is

vital that all units that you wish to locate and control are

set to their factory default settings. Otherwise they will

not be located by the AIM server. If necessary, perform a

manual factory reset on each ALIF unit. See center pages.

INFINITY 4000

™

Quick Start

ALIF4000 RX