ConceptBlindsDirect Aquarius Instrucciones de uso

Navegue en línea o descargue pdf Instrucciones de uso para Persianas ConceptBlindsDirect Aquarius. ConceptBlindsDirect Aquarius 2 páginas. Wand controlled vertical blind

Imprimir página

How to Fit & Operate your Wand Controlled Vertical Blind

You should have:

First check you've got

all the fittings that

come with your blind.

Wood screws: x 4

Getting started

YOU WILL NEED:

• A drill with correct bit

• A crossheaded

screwdriver

• A metal tape measure

• A pencil

• Your brackets are

packed with your

headrail. Please ensure

you've located them

before disposing of the

packaging.

• There are two bracket

types. One that can be

used to top fix the blind

into a recess and

another to face fix into

a frame or a wall.

• Please read the

following instructions

carefully before you

start fitting your blind.

Top fix brackets: x 2 min

Stabilising chains: x 2

To Fit the Brackets

1. Position the brackets at a suitable distance

away from any window handles or. If top fixing,

use a louvre hanger as a guide to positioning

your holes. If face fixing, mark where the

screws will go using the holes in the bracket as

a guide.

2. Ideally, position the brackets 5cm in from each

end of the head rail. Any additional brackets

should be spaced evenly.

3. For a wall or lintel, use a drill with a suitable

sized bit to make your holes, and push in

rawplugs. You may need different screws from

those provided i.e. 1½" 8's

4. For a wooden frame, screw your brackets into

position with the screws provided. A pilot hole

may be needed to allow easier fixing of the

screws.

5. Fix the bracket into place and repeat on the

other side of the blind.

To fit the head rail

Face fix

- loosen the screws on the front of the

brackets, hook the head rail into position and

tighten the bracket screws to secure.

Top fix

- with the thumb tab on the bracket

facing back, hook the front edge of the head

rail into the bracket and push up at the back

until it clicks into position.

Face fix bracket:

x2 min

Wand: x 1

Rawplugs: x 4

Short

screw

Page 1

Louvre hanger:

x 1 per louvre

Standard fixings for the most common installations supplied

Fit the Wand

1. To fit the wand, hook

onto the eyelet found

within the headrail.

2. Using the wand, turn

the hooks inside the

headrail that hold the

louvres to the open

position.

Alan Key

Weight: x1